Abstract:We report on the enhancement of the heat transfer of a commercial thermal compound after incorporation of certain carbon nanomaterials. Carbon nanotubes and carbon nanospheres, characterized by transmission electron microscopy, were diffused in a thermal epoxy compound following a precisely developed protocol based on sonication. The heat transmission of these fabricated thermal interface materials was tested using a setup designed to monitor heat dissipation and transmission to the cooling system under simulated operating conditions of standard electronic components. The data were recorded every 10 seconds by an in house built data acquisition system controlled by LabVIEW software. The effect of the amount of the carbon nanomaterials incorporated in the thermal interface compound was investigated, including reproducibility of the recorded results. The incorporation of the carbon nanomaterials showed an improvement in the thermal properties of the fabricated thermal interface materials. The highest achieved heat transfer has been measured for thermal interface materials fabricated with 1% of carbon nanomaterials corresponding to a maximum temperature drop of 2 °C. In addition, the thermal resistance of the thermal interface material used was characterized by the steady state approach. The measurements revealed lowest thermal resistance values of 80.14 and 100.9 mm 2 K/W corresponding to the thermal interface materials containing 1% of carbon nanotubes and carbon nanospheres respectively. The aim was to incorporate the new developed thermal interface materials in the low voltage power supply electronics as part of the upgrade of the ATLAS detector at CERN, and to be integrated in electronic devices in general in order to protect the important electronic components from damage and overheating and thus expand their life span.

Heat Conduction Enhancement of a Thermal Interface Material for Heat Sink Applications Using Carbon Nanomaterials

Fabrication of Three-dimensional Thermally Conductive Carbon Fibers/Carbon Nanotubes Network Reinforce Epoxy Composites

Interfacial Heat Flow in Carbon Nanotube Suspensions

Nanoengineering Heat Transfer Performance At Carbon Nanotube Interfaces

Nanoscale Heat Transport of Vertically Aligned Carbon Nanotube Bundles for Thermal Management Applications

Carbon nanotubes grafting aminated epoxy resin with improved elasticity and surface adhesion for enhanced thermal management performance

Improving Thermal Transport at Carbon Hybrid Interfaces by Covalent Bonds

Thermal Conductance Enhancement of Particle-Filled Thermal Interface Materials Using Carbon Nanotube Inclusions

Carbon nanotube composites for thermal management

The Carbon Nanotube Based Nanocomposite with Enhanced Thermal Conductivity

Enhanced Heat Transfer of Carbon Nanotube Nanofluid Microchannels Applied on Cooling Gallium Arsenide Cell

Experimental investigation of nano-coating effects on extended surfaces for enhanced thermal management of heat sinks

Remarkably enhanced thermal transport based on a flexible horizontally-aligned carbon nanotube array film

Enhanced Thermal Conductivity of Free-Standing Double-Walled Carbon Nanotube Networks

High Thermal Conductivity Carbon Nanomaterials for Improved Thermal Management in Armament Composites

New Nano-Thermal Interface Material for Heat Removal in Electronics Packaging

Superior Thermal Interfaces Made by Metallically Anchored Carbon Nanotube Arrays

Vertically Aligned Multi-Walled Carbon Nanotube Arrays As Thermal Interface Materials And Measurement Technique

Fabrication and Effective Thermal Conductivity of Multi-Walled Carbon Nanotubes Reinforced Cu Matrix Composites for Heat Sink Applications

An Experimental Study of Spectral Radiative Properties of Multi-Walled Carbon Nanotube Coating for Heat Dissipation