Abstract:Thermal phenomena such as heat transfer enhancement, heat transfer deterioration, and flow instability observed at supercritical pressures as a result of fluid property variations have the potential to affect the safety of design and operation of Supercritical Water-cooled Reactor SCWR, and also challenge the capabilities of both heat transfer correlations and Computational Fluid Dynamics CFD physical models. These phenomena observed at supercritical pressures need to be thoroughly investigated. An experimental study was carried out by Xi to investigate flow instability in parallel channels at supercritical pressures under different mass flow rates, pressures, and axial power shapes. Experimental data on flow instability at inlet of the heated channels were obtained but no heat transfer data along the axial length was obtained. This numerical study used 3D numerical tool STAR-CCM+ to investigate heat transfer at supercritical pressures along the axial lengths of the parallel channels with water ahead of experimental data. Homogeneous axial power shape HAPS was adopted and the heating powers adopted in this work were below the experimental threshold heating powers obtained for HAPS by Xi. The results show that the Fluid Centre-line Temperature FCLT increased linearly below and above the PCT region, but flattened at the PCT region for all the system parameters considered. The inlet temperature, heating power, pressure, gravity and mass flow rate have effects on WT (wall temperature) values in the NHT (normal heat transfer), EHT (enhanced heat transfer), DHT (deteriorated heat transfer) and recovery from DHT regions. While variation of all other system parameters in the EHT and PCT regions showed no significant difference in the WT and FCLT values respectively, the WT and FCLT values respectively increased with pressure in these regions. For most of the system parameters considered, the FCLT and WT values obtained in the two channels were nearly the same. The numerical study was not quantitatively compared with experimental data along the axial lengths of the parallel channels, but it was observed that the numerical tool STAR-CCM+ adopted was able to capture the trends for NHT, EHT, DHT and recovery from DHT regions. The heating powers used for the various simulations were below the experimentally observed threshold heating powers, but heat transfer deterioration HTD was observed, confirming the previous finding that HTD could occur before the occurrence of unstable behavior at supercritical pressures. For purposes of comparing the results of numerical simulations with experimental data, the heat transfer data on temperature oscillations obtained at the outlet of the heated channels and instability boundary results obtained at the inlet of the heated channels were compared. The numerical results obtained quite well agree with the experimental data. This work calls for provision of experimental data on heat transfer in parallel channels at supercritical pressures for validation of similar numerical studies.

Structural Effect of a Staggered-Blade-type Grid Spacer on the Flow and Heat Transfer Characteristics of Supercritical Water in a Triangular Core Channel.

Effects of Rectangular-Type Spacer on Hert Transfer and Flow in Coolant Passage.

Numerical simulation prediction of critical heat flux for 5 × 5 rod bundle with multiple grid spacers and different cladding materials

Heat transfer deterioration in a supercritical water channel

Numerical study on heat transfer characteris tics of supercritical water in straight and helical tubes

The numerical investigation of the thermal–hydraulic behavior in a 3 × 3 rod bundle with spacer grids

Numerical Verifications on Heat Transfer to Supercritical Water Flowing Upward in a 4-m Long Bare Vertical Tube

A fundamental study of the heat transfer and flow situation around a spacer (In the case of a circular cylinder as a spacer.

Effect of Circumferential Flow Non-uniformity on the Temperature Distribution of Membrane Water Wall in Supercritical Boilers and Simplified Calculation Methods

Fundamental study of heat transfer and flow situation around a spacer (in the case of a cylindrical rod as a spacer)

Heat transfer of supercritical pressure water in helical tubes

Flow mixing and heat transfer deterioration investigation of supercritical carbon dioxide in wire-wrapped bundles

Numerical Investigation of Supercritical Water Turbulent Flow and Heat Transfer Characteristics in Vertical Helical Tubes

Comparisons of Supercritical Loop Flow and Heat Transfer Behavior under Uniform and Nonuniform High-Flux Heat Inputs

NUMERICAL INVESTIGATION ON HEAT TRANSFER TO SUPERCRITICAL WATER FLOWING UPWARD IN A 4-M LONG BARE VERTICAL CIRCULAR TUBE

Effects of Thermal Boundary Conditions on Heat Transfer Characteristics of Supercritical Water

Experimental study on heat transfer in vertical cooling tube cooled by downward flow in the passive heat removal system of SCWR

Analysis of stream flow and its impact on thermal performance in shell-side of heat exchangers based on flow dead zone

Numerical investigation of heat transfer in parallel channels with water at supercritical pressure

Assessment of heat transfer correlations in the sub-channels of proposed rod bundle geometry for supercritical water reactor

Influences of Tube Wall on the Heat Transfer and Flow Instability of Various Supercritical Pressure Fluids in a Vertical Tube