Abstract:PurposeThe effect of the stacking sequence and arrangement of layers in the use of carbon/epoxy and glass/epoxy are studied on the vibration behavior of a rotating hybrid composite shaft.MethodsIn this paper, a hollow fiber-based hybrid composite shaft (HCS) with continuously extended fiber reinforcement consisting of carbon/epoxy and glass/epoxy layers with a symmetrical stacking sequence is modeled and built using the filament winding method. Strain potential energy is computed using Euler Bernoulli's theory and determining longitudinal stiffness, bending stiffness, torsional stiffness, and axial–torsional coupling. By using Hamilton's principle, the governing equations of motion are derived. The multiple scales method is used to obtain the approximate analytical answer of the HCS motion equations.ResultsBy solving the motion equations of the system, considering both the unbalanced mass of the shaft and disk, as well as the unbalanced mass of the shaft, natural frequencies are extracted for the 28-layer HCS with a centrally located disk and elastic bearings. The natural frequencies of analytical and numerical solutions of HCS with a centrally located disk and flexible supports are compared and validated. Then the natural frequencies of the non-rotating HCS are obtained using the modal analysis test and compared with the natural frequencies of the numerical solution, and the results are verified. The first three natural frequencies of the HCS with one disk supported by two elastic bearings are presented for various stacking sequences.ConclusionsThe maximum natural frequencies of the rotating HCS with a disk positioned centrally on the shaft supported by two elastic bearings, occurred in an asymmetrical stacking sequence where eight layers of carbon/epoxy constituted the outermost layers of the HCS. Given the high torsional and bending stiffness of the carbon/epoxy, it is preferable to utilize it in the outer layers of the HCS.

Structural Design and Dynamic Analysis of Carbon Fiber Reinforced Plastic Shaft with Metal Parts

Mechanical Analysis and Optimal Design for Carbon Fiber Resin Composite Wound Hydrogen Storage Vessel With Aluminum Alloy Liner

Static property analyses based on finite element method and torsion tests on carbon fibre composite motor drive shaft

Design and analysis of the mandrel structure for a composite S-shaped inlet

Modal analysis based on finite element method and experimental validation on carbon fibre composite drive shaft considering steel joints

Mechanical properties analysis and experimental study of double-lap mechanically connected carbon fiber drive shafts

Evaluation of Machine Tool Spindle Using Carbon Fiber Composite

Material design and failure experiment of a carbon fibre reinforced plastics drive shaft

Vibration Characteristics and Machining Performance of Carbon Fiber Reinforced Shaft in Poor Rigidity Machining Tool System

FE Analysis of Stress Concentrations in Composite Plates with Multiple Holes for Zigzag Multi-Fastened Joints

Dynamic design and transmission performance analysis based on CF/PEEK composite for short flexspline harmonic drive

Investigation of Vibrational Behavior of the Hybrid Composite Shaft Using Experimental, Analytical, and Numerical Method

A CFRP/steel hybrid rotating shaft for a high-speed motorized spindle

FUNDAMENTAL FREQUENCY MAXIMIZATION DESIGN FOR CONTINUOUS FIBER-REINFORCED COMPOSITE STRUCTURES

Design of a Composite Drive Shaft and its Coupling for Automotive Application

Optimisation of hybrid high-modulus/high-strength carbon fiber reinforced plastic composite drive

Frequency and Reliability Analysis of Load-Bearing Composite Beams

Structure Design on Thermoplastic Composites Considering Forming Effects

Investigation on the torsional property of hybrid composite/metal shafts at different service temperatures: Experimental and analytical study

Crashworthiness analysis and multi-objective optimization of a novel metal/CFRP hybrid friction structures