Abstract:During the fabrication of an indium-gallium-zinc oxide (IGZO) thin film transistor (TFT), the thermal process was used to reduce the resistivity of IGZO. The annealing temperature was found to have great influence on the transistor characteristics. At an optimized heat-treatment temperature, the depletion-mode IGZO TFT was fabricated with steeper subthreshold slope, higher filed-effect mobility and acceptable turn-on voltage. And the relatively conductive IGZO could directly replace the indium tin oxide as the transparent electrode of the organic light-emitting diode (OLED), reducing the mask count of the backplane for the active-matrix OLED display. INTRODUCTION Thin film transistor (TFT) based on metal oxide (MO), especially, indium-gallium-zinc oxide (IGZO), is considered as a good candidate to fabricate large area backplane for active-matrix organic light-emitting diode (AMOLED) display, due to its high mobility, good uniformity and low off-state current [1]. Our previous study [2] suggested that the resistivity (ρ) of IGZO highly depended on the heat-treatment conditions, such as annealing ambience, temperature, duration and gas permeability of IGZO cover, while the thermal process was often inevitable during the fabrication of IGZO TFT. With the active layer of IGZO covered with the gas-permeable silicon oxide (SiOx), the TFT was subjected to a serious anneals in an oxygen-deficient nitrogen (N2) ambience. With the increasing temperature, although the mobility was enhanced, the turn-on voltage (Von) became more and more negative. At an optimized temperature, the depletion-mode (DM) IGZO TFT with steeper subthreshold slope, higher filed-effect mobility and acceptable turn-on voltage was fabricated. Furthermore, such annealing-induced conductive IGZO source/drain regions can be directly used to replace the indium tin oxide (ITO) as the transparent electrode of OLED, reducing the mask count of AMOLED backplane. Annealing-Induced DM IGZO TFT Shown in Figure 1 is the evolution of the schematic cross-section of an IGZO TFT. A gate dielectric of 100 nm silicon oxide (SiOx) was first thermally grown on an n+ silicon substrate, which served as the gate electrode. 10 or 20 nm IGZO film was then room-temperature sputtered using a target of In2O3:Ga2O3:ZnO = 1:1:1 mol% in an atmosphere of 10% oxygen (O2) and 90% argon (Ar). After the patterning of the active-island using the hydrofluoric acid, a passivation layer of 300 nm SiOx was deposited at 300 oC in a plasma-enhanced chemical vapor deposition (PECVD) reactor. The tetraethylorthosilicate (TEOS) and O2 were used as the source gases. The contact holes were then opened and the resulting structure was subjected to a series of anneals, as shown in Figure 1a. Finally, 300 nm aluminum (Al) was deposited and patterned into electrodes (Fig. 1b). These TFTs were measured using an Agilent 4156C semiconductor parameter analyzer. n+ Si 100nm SiOx 300nm SiOx

Polycrystalline InGaO Thin‐Film Transistors with Coplanar Structure Exhibiting Average Mobility of ≈78 cm2 V‐1 s‐1 and Excellent Stability for Replacing Current Poly‐Si Thin‐Film Transistors for Organic Light‐Emitting Diode Displays

81‐4: High Performance Coplanar Polycrystalline InGaO TFTs on Polyimide Substrate for Foldable AMOLED Display

High Performance Amorphous In0.5Ga0.5O Thin‐Film Transistor Embedded with Nanocrystalline In2O3 Dots for Flexible Display Application

Growth of high quality polycrystalline InGaO thin films by spray pyrolysis for coplanar thin-film transistors on polyimide substrate

As-Grown Crystalline InGaZnO by Spray Pyrolysis on a Flexible Substrate for a Thin-Film Transistor with Excellent Stability

Annealing-Induced Depletion-Mode Indium-Gallium-Zinc Oxide Thin-Film Transistor and Its Application to Active-Matrix Organic Light-Emitting Diode Display

High performance amorphous IGO TFTs grown at low temperature

High mobility of IGO/IGZO double-channel thin-film transistors by atomic layer deposition

Continuous Growth of Crystalline InGaZnO on InLaO by Spray Pyrolysis for High‐Performance Thin‐Film Transistors with Excellent Stability

Amorphous indium–gallium–zinc–oxide thin-film transistors using organic–inorganic hybrid films deposited by low-temperature plasma-enhanced chemical vapor deposition for all dielectric layers

Aqueous Solution Derived Amorphous Indium Doped Gallium Oxide Thin-Film Transistors

High-Performance Amorphous InGaZnO Thin Film Transistor With High-k Van Der Waals Molecular Dielectric

High-Performance Amorphous InGaZnO Thin-Film Transistor Gated by HfAlOₓ Dielectric with Ultralow Subthreshold Swing

Coplanar amorphous-indium-gallium-zinc-oxide thin film transistor with He plasma treated heavily doped layer

Room-Temperature-Processed Flexible Amorphous InGaZnO Thin Film Transistor.

Comparative Study of Atomic Layer Deposited Indium-Based Oxide Transistors with a Fermi Energy Level-Engineered Heterojunction Structure Channel through a Cation Combinatorial Approach

A-Igzo TFTs with Inductively Coupled Plasma Chemical Vapor Deposited ${\rm SiO}_{x}$ Gate Dielectric

Self-Aligned Top-Gate Metal-Oxide Thin-Film Transistors Using a Solution-Processed Polymer Gate Dielectric

P‐1.8: High Performance Amorphous IZO/IGZO Bilayer Thin Film Transistors for Ink‐jet Printed AMOLED Displays

P‐28: High‐speed Oscillator using Polycrystalline InGaO TFTs by Spray Pyrolysis on Polyimide Substrate for Flexible Electronics

(Invited) Short Channel Coplanar Amorphous-Indium-Gallium-Zinc-Oxide Thin-Film Transistors on Polyimide Substrate for High Resolution Displays