Abstract:Fringe patterns are typically produced as the results of traditional optical Nondestructive Evaluation (NDE) employing digital shearography. Structural flaws affect the response of the surrounding material to a certain loading, resulting in unique fringe patterns that are related to the local deformation. Smaller defect information, however, can be easily lost in the fringe pattern caused by global deformation during the flaw detection procedure. In order to improve the flaw detection capabilities of this technology, it is important to streamline the inspection process and to simplify the interpretation of the results. This study proposes a practical and effective methodology that experimentally removes fringe patterns caused by global deformation in digital shearography and only retains the defect information. For shearographic Non-Destructive Testing (NDT), two sets (3 or 4 images) of temporal phase-shifted interferograms under different loads P 1 and P 2 are recorded. This novel approach involves recording one additional set of temporal phase-shifted interferograms at a load between P 1 and P 2 , e.g. P 1' . Two phase maps of shearograms can be generated using the phase shift technique, corresponding to the two loads Δ 2 = (P 1' -P 1 ) and Δ 1 = (P 2 -P 1 ), respectively. Because of the nondestructive nature of the testing, the magnitude of the loads P 1 and P 2 is small, and the 1st derivative of global deformation in the shearing direction of the test part is assumed to be linear. Therefore, a linear coefficient C based on the two shearograms can be determined. The information from global deformation is then removed by subtracting the shearogram generated with the small load Δ 2 multiplied by the correlation coefficient C from the one obtained with the relatively large load Δ 1 . This technique is further improved by calculating a complete surface linear coefficient C ij , which improves the detail processing of the deformation of samples with complex geometry and mechanical properties. This technique is shown to effectively assess a wide range of structures, including aluminum specimens with prepared flaws and intricate composite laminates. The experimental findings demonstrate that the suggested technique improves the non-destructive testing capabilities of digital shearography, thereby simplifying defect detection and visualization.

The Nyquist criterion and its relevance in phase-stepping digital shearography: a quantitative study

High-Sensitivity Quantitative Phase Microcopy

High-sensitivity Quantitative Phase Microcopy (conference Presentation)

Quantitative Phase and Amplitude Imaging with an Efficient Support Constraint.

Quantitative Phase Imaging Based on Wavefront Correction of a Digital Micromirror Device

Quantitative diagnosis of the out-of-plane displacement derivative with temporal-phase-shift shearography

Digital shearography for NDT: Study on a novel experiment based method for removing global deformation ✰

Sub-Nyquist Sampling: Bridging Theory and Practice

A Shear Wave Elastography Method Based on 2D Savitzky-Golay Digital Differentiator

Simultaneous Measurement of Deformation and the First Derivative with Spatial Phase-Shift Digital Shearography

The application of SLM in shearography detecting system

A Novel Phase Shifting Technique of Coherent Gradient Sensing Method for Measuring Crack-tip K -Dominance

Dynamic Phase Measurement in Shearography by Clustering Method and Fourier Filtering

Dynamic Measurement of First-Order Spatial Derivatives of Deformations by Digital Shearography

Noise Analysis Directly on Shearography Wrapped Phase Maps

Phase Extraction by Spiral Phase Transform in Digital Shearography

High-performance digital shearography integrating spatial light modulator with micro-polarizer camera

Dynamic Phase Measurement in Shearography by Clustering Method

One-bit Quantization SAR Imaging Using Phaseless Measurements

Anti-aliasing high resolution quantitative phase microscopy based on differential phase contrast imaging

Dynamic range enhancement algorithms for CMOS sensors with non-destructive readout