Abstract:Abstract The integration of metals and polymers in the same component to couple the best properties and advantages of both these classes of materials can be useful for engineering applications. In this scenario, the aim of this paper is to integrate additive manufacturing of composites with cold spray deposition of metal particles: in particular, 3D-printed carbon fibre-reinforced plastics (CFRP) panels were coated with aluminium particles to couple the lightweight and high mechanical properties of CFRP with high wear resistance and hardness of metals. CFRP panels have been produced by using the Fused Filament Fabrication (FFF) technology, then the panels have been coated with aluminium particles by using a low pressure cold spray facility. Panels with various stratification sequences have been produced to investigate the feasibility of the process and to highlight the influence of the lay-up strategy on the whole process; the parameters of the cold spray process have been also optimized to ensure an effective deposition. Adhesion tests, distortion measurements, cross-section observations and surface coverage measurements have been chosen as response outputs to evaluate the effectiveness of the process and to assess the influence of the process parameters. The integration between FFF of CFRPs and cold spray deposition of aluminium particles has been proved, values of surface coverage close to 100% and good values of adhesion strength (close to 4 MPa) have been achieved; moreover, the presence of the fibres, giving a higher stiffness to the substrate, avoids the occurrence of distortion phenomena during the deposition. It was also proved that the printing parameters influence the deposition: an increase in the infill density from 30% to 50% leads to an increase in the adhesion strength up to 40%. In summary, the results obtained proved the feasibility of the process and allowed to enucleate directions of future research.

Cold Sprayed Metallic Coatings on Fibre-Reinforced Composites: A Machine Learning Approach for the Optimization of the Process

Machine Learning for Materials Developments in Metals Additive Manufacturing

Study of Bonding Mechanisms in Cold Spray of Metal-to-Polymer through a Numerical Approach

Analysis of Data Generation and Preparation for Porosity Prediction in Cold Spray using Machine Learning

Additive manufacturing: Application and validation of machine learning-based process-structure-property linkages in Ti-6Al-4V

Advancements in Cold Spray Additive Manufacturing: Process, Materials, Optimization, Applications, and Challenges

Application of machine learning for the prediction of particle velocity distribution and deposition efficiency for cold spraying titanium powder

Machine Learning-Based Predictions of Porosity during Cold Spray Deposition of High Entropy Alloy Coatings

Manufacturing of a Metal Matrix Composite Coating on a Polymer Matrix Composite Through Cold Gas Dynamic Spray Technique

Integrating 3D printing of polymer matrix composites and metal additive layer manufacturing: surface metallization of 3D printed composite panels through cold spray deposition of aluminium particles

Microhardness and wear resistance in materials manufactured by laser powder bed fusion: Machine learning approach for property prediction

Cold Spray Technology and Its Application in the Manufacturing of Metal Matrix Composite Materials with Carbon-Based Reinforcements

A predictive modeling approach for cold spray metallization on polymers

A comprehensive investigation on application of machine learning for optimization of process parameters of laser powder bed fusion-processed 316L stainless steel

New Process Implementation to Enhance Cold Spray-Based Additive Manufacturing

AI-based machine learning prediction for optimization of copper coating process on graphite powder for green composite fabrication

Computational Analysis of Cold Spraying Polymer-Coated Metallic Particles on Fiber-Reinforced Polymer Substrates

Characterisation and prediction of mechanical properties in laser powder bed fusion-printed parts: a comparative analysis using machine learning

Machine learning approach towards laser powder bed fusion manufactured AlSi10Mg thin tubes in laser shock peening

A new intelligent approach of surface roughness measurement in sustainable machining of AM-316L stainless steel with deep learning models

Cold spray deposition of metallic coatings on polymers: a review