Hydrophilic surface-modified titanium-based lithium ion sieve adsorbents for efficient lithium extraction
Yaru Qin,Xingyu Yang,Ling Zeng,Jiguang Dong,Qiangqiang Bi,Qihui Wang,Shuqi Qiu,Jiayi Xu,Qipeng Zhang,Chenglong Shi
DOI: https://doi.org/10.1016/j.molliq.2024.125896
IF: 6
2024-09-06
Journal of Molecular Liquids
Abstract:Titanium-based lithium ion sieve adsorbents (HTOs) are considered among the most promising materials for lithium extraction from aqueous sources. In this study, four surfactants—sodium dodecyl sulfate (SDS), cetyltrimethylammonium bromide (CTAB), hydroxypropyl cellulose (HPC), and tannic acid (TA)—were used to surface-etch HTOs, preparing adsorbents with enhanced hydrophilicity at the nanoscale. Correlation studies between the hydrophilicity of the HTO-X and their adsorption performance revealed that all HTO-X had lower contact angles than the unetched counterparts, indicating improved adsorption capacities. Notably, TA plays a synergistic role of "killing two birds with one stone". The TA-etched HTO-T adsorbent exhibited the lowest contact angle (8.8°) and the highest specific surface area (62.10 m 2 /g). In a LiCl solution, HTO-T's adsorption capacity for Li + reached 33.61 mg/g, a 26 % increase over the unetched HTO adsorbent (26.56 mg/g). Simultaneously, HTO-T significantly reduces the adsorption time and enhances the adsorption efficiency during the surface diffusion phase. Additionally, HTO-T demonstrated remarkable selectivity for lithium ions, with separation factors α(Li/Na), α(Li/K), α(Li/Mg), and α(Li/Ca) of 397.13, 181.55, 1288.47, and 1345.19, respectively, showcasing an excellent separation effect. The adsorption mechanism indicates that Li + adsorption by HTO-T primarily occurs through the disruption of O–H bonds and the formation of new O-Li bonds. This research presents an efficient strategy for the development of HTOs, demonstrating HTO-T as a potential adsorbent for lithium recovery from brine sources.
chemistry, physical,physics, atomic, molecular & chemical