Abstract:Quantitative phase analysis (QPA) using the Rietveld method and X-ray diffraction (XRD) patterns is useful for predicting the reactivity of a rock to carbon dioxide (CO 2 ) and for quantifying mineral carbonation. Lizardite and smectites in kimberlite are reactive to CO 2 , but they are structurally disordered and cannot be quantified using the standard Rietveld approach. In this study, the Partial Or No Known Crystal Structure (PONKCS) method was used to model the peak profiles of a smectite and lizardite to account for turbostratic stacking disorder in synthetic samples of processed kimberlite. Lizardite and montmorillonite PONKCS models were made using XRD patterns collected with three X-ray diffractometers: two XRDs from the same manufacturer and of similar model (XRDs B1 and B2) and another XRD from a different manufacturer (XRD A1). Five synthetic samples of processed kimberlite of known compositions were prepared and used to test the results of these PONKCS models for data collected from all three instruments. The results provide a total bias ranging from 4.2–14.1 wt.% using correctly calibrated, instrument-specific PONKCS models. We also tested the sensitivity of the PONKCS method to changes in instrument geometry: PONKCS models calibrated for one instrument (XRD B1) were used in refinements with XRD data collected on an instrument made by a different manufacturer (XRD A1), or on a similar instrument made by the same company but having a slightly different geometry (XRD B2). Results were highly inaccurate when PONKCS models calibrated to XRD B1 were used with patterns collected on XRD A1 (32.1–71.6 wt.% total bias for our weighed mixtures). Our results show that the smaller differences in instrument parameters between XRD B1 and XRD B2 can also lead to inconsistent and less accurate QPA results using PONKCS (9.8–32.7 wt.% total bias). Therefore, correct calibration of PONKCS models to a specific XRD instrument is required for accurate QPA and quantification of CO 2 mineralization in clay-rich rocks.

Strategies for XRD quantitative phase analysis of ordinary and blended Portland cements

Interactions Between Organic and Inorganic Phases in PA- and PU/PA-Modified-Cement-Based Materials

Phase Analysis of Portland Cement by Combined Quantitative X-Ray Powder Diffraction and Scanning Electron Microscopy.

Microstructure Refinement of Calcium-Sulfate-aluminate and Portland Cement (CSA-PC) Hybrids with Accelerated CO2 Curing (ACC)

Mix and measure II: joint high-energy laboratory powder diffraction and microtomography for cement hydration studies

Phase quantification of anhydrous CSA cements: a combined X-ray diffraction and Raman imaging approach

Quantifying the potential for mineral carbonation of processed kimberlite with the Rietveld-PONKCS method

Phase analysis and hydration behavior of fine and coarse particle fractions contained in a commercial Portland cement

On-line X-ray diffraction for quantitative phase analysis: Application in the Portland cement industry

Phase Quantification in Cementitious Materials by Dynamic Modulus Mapping

NMR, XRD, IR and synchrotron NEXAFS spectroscopic studies of OPC and OPC/slag cement paste hydrates

Portland/Sulfoaluminate Cement Blends for the Control of Early Age Hydration and Yield Stress

A combined SPM/NI/EDS method to quantify properties of inner and outer C-S-H in OPC and slag-blended cement pastes

Critical strain measurements of hydrating Portland cement pastes: A new understanding of microstructure development

An efficient method for determining the pozzolanic reaction degrees of low-calcium supplementary cementitious materials in blended cement pastes

XRD investigation of cement pastes incorporating concrete floor polishing waste

XRF and XRPD data sets in ternary mixtures with high level micro-absorption and/or preferred orientations problems for phase quantification analysis

A Scanning Transmission X-ray Microscopy Study of Cubic and Orthorhombic C3A and Their Hydration Products in the Presence of Gypsum

Rheological behavior of Portland clinker-calcium sulphoaluminate clinker-anhydrite ternary blend

Revealing the substitution preference of zinc in ordinary Portland cement clinker phases: A study from experiments and DFT calculations

Microscopic phase identification of cement-stabilized clay by nanoindentation and statistical analytics