Abstract:AZ31 Mg alloy with heterogeneous bimodal grain structure (smaller grain size of 5–20 µm and coarser grain size of 100–200 µm) was subjected to accumulated extrusion bonding (AEB) at 250 ℃ combined with two-stage artificial cooling in this work, viz. local water cooling and artificial cooling. The microstructure developed consecutively as a result of discontinuous dynamic recrystallization (DDRX) for the AEBed samples. {10–12} tensile twinning also played an important role for the AEB with local water cooling at the initial extrusion stage in the container. Local water cooling could further reduce the DRXed grain size to ~ 2.1 µm comparing that without water cooling. And the grain growth rate was reduced by artificial cooling out of extrusion die. Under the combination of two-stage cooling, the fine DRXed grains at sizing band were almost retained with average grain size of ~ 2.3 µm after the sheet out of extrusion die, and the unDRXed grains with high residual dislocation density accumulation were also reserved. The tensile tests results indicated that a good strength-ductility balance with a high ultimate tensile strength (319 MPa vs. 412 MPa) and fracture elongation (19.9 % vs. 30.3%) were obtained. The strength enhancement was mainly owing to the grain refinement and local residual plastic strain reserved by the artificial cooling. The excellent ductility originated from fine DRXed microstructure and ED-tilt double peak texture.

Grain refinement and mechanical properties of pure aluminum processed by accumulative extrusion bonding

Enhancing grain refinement and mechanical properties of AA1100/MgAZ31/AA1100 composites by using different roll bonding techniques

Microstructural Evolution and Mechanical Properties of Multi-layered Aluminum Alloy 6061 Processed by Accumulative Roll Bonding

Strength-ductility balance of AZ31 magnesium alloy via accumulated extrusion bonding combined with two-stage artificial cooling

Mechanical responses, texture and microstructural evolution of high purity aluminum deformed by equal channel angular pressing

Ultrafine-grained Al–Zn–Mg–Cu alloy processed via cross accumulative extrusion bonding and subsequent aging: Microstructure and mechanical properties

Effect of Alloying Elements and Processing Parameters on Microstructure and Properties of 1XXX Aluminium Alloys

Severe plastic deformation of commercially pure aluminum using novel equal channel angular expansion extrusion with spherical cavity

Extra strengthening and strain hardening in coarse-grain/ultrafine-grain laminates

Grain Refinement and Strengthening of an Aluminum Alloy Subjected to Severe Plastic Deformation through Equal-Channel Angular Pressing

Effect of extrusion-ECA integrated large strain technology on microstructure and properties of 7075 aluminum alloy

Microstructural evolution and mechanical properties of AZ31 Mg alloy fabricated by a novel bifurcation-equal channel angular pressing

Effects of annular channel angular extrusion process and heat treatment on microstructure and mechanical properties of 2A12 aluminum alloy cabin

Role of Grain Refinement Mechanism on Microstructure and Performance in AZ31B Alloy During Interactive Alternating Forward Extrusion (AFE) Process

Improving Mechanical Properties of Chips-Based Aluminum Extrudates by Composite Hot Extrusion

Effect of ECAP on microstructure uniformity and mechanical properties of high purity aluminum

Microstructural Evolution and Mechanical Properties of Pure Aluminum upon Multi-Pass Caliber Rolling

Enhancing of aluminum alloy 1050-H4 tensile strength by accumulative roll bonding process

Evolution of texture and microstructure during accumulative roll bonding of aluminum AA5086 alloy

Effect of Grain Size on Formability and Deformation Mechanism of High‐Purity Aluminum during Micro‐Embossing Process at Elevated Temperature

Mechanical Properties and Microstructure of AZ31 Mg Alloy Processed by Two-Step Equal Channel Angular Extrusion