Abstract:Abstract. A chelating matrix prepared by immobilizing 1,8-dihydroxyanthraquinone on silica gel modified with 3-aminopropyltriethoxysilane has been characterized by use of cross-polarization magic angle spinning (CPMAS) NMR, diffuse reflectance infrared Fourier transformation (DRIFT) spectroscopy, and thermogravimetric analysis and used to preconcentrate Fe(III), Co(II), Ni(II), and Cu(II) before their determination by flame atomic absorption spectrometry. The optimum pH ranges for quantitative sorption are 6.5–8.0, 6.0–7.0, 6.0–8.0, and 7.0–8.5 for Cu, Fe, Co, and Ni, respectively. All the metal ions can be desorbed with 2 mol L–1 HCl or HNO3. The sorption capacity (µmol g–1 matrix) and preconcentration factor were 226.6, 250; 365.6, 300; 101.8, 150; and 109.0, 250 for Cu, Fe, Co, and Ni, respectively. The lowest concentration for quantitative recovery was 4.0, 3.3, 6.6, and 4.0 ng mL–1, respectively for the four metal ions. The limits up to which electrolytes NaNO3, NaCl, NaBr, Na2SO4, and Na3PO4 and cations Ca(II) and Mg(II) can coexist with the four metal ions during their sorption without adverse effect are reported. The simultaneous enrichment and determination of all the four metals is possible if the total load of metal ions is less than the sorption capacity. Flame AAS was used to determine the metal ions in underground, tap, and river water samples (RSD≤7.1%) after their enrichment with the matrix. The cobalt content of pharmaceutical samples (multivitamin tablet) preconcentrated by use of this silica gel matrix and determined by FAAS was found to be 2.00 µg g–1, with RSD˜1.7% (reported concentration level, 1.99 µg g–1).

Solid-phase extraction using multiwalled carbon nanotubes and quinalizarin for preconcentration and determination of trace amounts of some heavy metals in food, water and environmental samples

Solid phase extraction of heavy metal ions in environmental samples on multiwalled carbon nanotubes

Preconcentration of some trace elements via using multiwalled carbon nanotubes as solid phase extraction adsorbent

Dispersive Liquid–Liquid Microextraction and Micro-Solid Phase Extraction for the Rapid Determination of Metals in Food and Environmental Waters

Solid phase extraction of heavy metal ions based on a novel functionalized magnetic multi-walled carbon nanotube composite with the aid of experimental design methodology

Dispersive Micro‐Solid Phase Extraction of Selected Metals in Water and Food Samples Followed by ICP‐OES Analysis: Method Development, Analysis of Real Samples and Greenness Evaluation

Determination of Cobalt (II), Copper (II), Lead (II), and Zinc (II) with Preconcentration by 8-Hydroxyquinoline-Coated Magnetic Nanoparticles (MNPs) and Microinjection Sampling–Flame Atomic Absorption Spectrometry (MIS–FAAS)

Simultaneous on-line preconcentration and determination of trace metals in environmental samples using a modified nanometer-sized alumina packed micro-column by flow injection combined with ICP-OES

INDICATIONS AND TECHNIQUE OF CRYOEXTRACTION OF CATARACTS.

Preparation of modified multiwalled carbon nanotubes (l-Arg-CS/MWCNTs-COOH/Fe3O4) as sorbent for dispersive solid phase extraction of Cu(II), Pb(II) and Cd(II) in wastewater samples

Detection of 13 mycotoxins in feed using modified QuEChERS with dispersive magnetic materials and UHPLC-MS/MS.

Selective solid phase extraction and preconcentration of mercury(II) from environmental and biological samples using nanometer silica functionalized by 2,6-pyridine dicarboxylic acid

Solid phase extraction and trace monitoring of cadmium ions in environmental water and food samples based on modified magnetic nanoporous silica

Magnetic Luffa@metal-organic frameworks (MOF-199) nanocomposite for the solid phase microextraction of some metal ions at trace levels from food and water samples

Ultrasound assisted magnetic solid phase extraction of copper(II) and lead(II) in environmental samples on Magnetic Activated Carbon Cloth

Vortex-assisted magnetic solid-phase extraction of cadmium in food, medicinal herb, and water samples using silica-coated thiol-functionalized magnetic multiwalled carbon nanotubes as adsorbent

Enrichment of iron(III), cobalt(II), nickel(II), and copper(II) by solid-phase extraction with 1,8-dihydroxyanthraquinone anchored to silica gel before their determination by flame atomic absorption spectrometry

A MWCNTs@CuAl2O4@SiO2 Nanocomposite for the Speciation of Cr(III), Cr(VI), and Total Chromium Prior to High-Resolution Continuum Source Flame Atomic Absorption Spectrometric Determination

Preconcentration of Some Heavy Metals with Novel Electrospun Nanofiber Including Quince Seed Mucilage

A Magnetized Nanoparticle Based Solid-Phase Extraction Procedure Followed by Inductively Coupled Plasma Atomic Emission Spectrometry to Determine Arsenic, Lead and Cadmium in Water, Milk, Indian Rice and Red Tea

Chemically Modified Activated Carbon With 1-Acylthiosemicarbazide For Selective Solid-Phase Extraction And Preconcentration Of Trace Cu(Ii), Hg(Ii) And Pb(Ii) From Water Samples