Abstract:Quantification of ultra-trace inorganic and organic species of lead and mercury in unpolluted environmental water is crucial to estimate the mobility, toxicity and bioavailability and interactions. Simultaneous pre-concentration of Pb and Hg species in pg L-1 levels followed by multi-elemental speciation analysis makes great sense to a large set of unstable samples because of time advantages. Herein simultaneous enrichment and speciation analysis of ultra-trace lead and mercury in water was developed by online solid-phase extraction coupled with high performance liquid chromatography and inductively coupled plasma mass spectrometry (SPE-HPLC-ICP-MS) for this aim. Pb(II), trimethyl lead (TML), triethyl lead (TEL), Hg(II), methylmercury (MeHg) and ethylmercury (EtHg) were baseline separated in 11 min under gradient elution using 5 mM L-cysteine (Cys) at pH 2.5 in the 0-1 and 4-15 min and 5 mM Cys + 0.5 mM tetrabutyl ammonium hydroxide solution at pH 2.5 in the 1-4 min. Lead and mercury species in 10 mL intact water samples were adsorbed on a 1 cm C18 enrichment column preconditioned with 10 mL of 1 mM 2-mercaptoethanol at 10 mL min-1, and then directly desorbed by the mobile phases. High enrichment factors (459 for Pb(II), 1248 for TML, 1627 for TEL, 2485 for Hg(II), 1984 for MeHg and 1866 for EtHg) were obtained with good relative standard deviations (<5%), leading to low LODs (0.001-0.011 ng L-1) and LOQs (0.004-0.036 ng L-1). Good accuracy of this method was validated by two certified reference materials of total lead in water (GBW08601) and total mercury in water (GBW08603) along with spiked recoveries (89-93%). The method was applied to analyze trace lead and mercury species in river, lake, tap and rain water, and purified and mineral water. Inorganic lead of 13-68 ng L-1 and inorganic mercury of 21-49 ng L-1 were measured in the nine water samples whereas TML, TEL and MeHg were not detected with 2-5 ng L-1 EtHg presented only in one river water and tap water. (c) 2021 Elsevier B.V. All rights reserved.

Chemically Modified Activated Carbon With 1-Acylthiosemicarbazide For Selective Solid-Phase Extraction And Preconcentration Of Trace Cu(Ii), Hg(Ii) And Pb(Ii) From Water Samples

Chemically Modified Activated Carbon With S-Benzyldithiocarbazate As A New Solid-Phase Extractant For Preconcentration Of Mercury Prior To Icp-Aes Determination

Carbon/Alginate/Chitosan Composite as a Sorbent for Solid-Phase Extraction and Preconcentration of Cu(II)

Simultaneous Measurements of Cr, Cd, Hg and Pb Species in Ng L-1 Levels by Interfacing High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry.

Graphene oxide as an efficient adsorbent of solid-phase extraction for online preconcentration of inorganic and organic mercurials in freshwater followed by HPLC-ICP-MS determination

Silica Gel Modified with 1-(2-aminoethyl)-3-phenylurea for Selective Solid-Phase Extraction and Preconcentration of Sc(III) from Environmental Samples

Selective solid phase extraction and preconcentration of mercury(II) from environmental and biological samples using nanometer silica functionalized by 2,6-pyridine dicarboxylic acid

High Efficient Removal of Cu(II) by a Chelating Resin from Strong Acidic Solutions: Complex Formation and DFT Certification

Simultaneous Enrichment of Inorganic and Organic Species of Lead and Mercury in Pg L−1 Levels by Solid Phase Extraction Online Combined with High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry

Preparation of Cotton-Based Fibrous Adsorbents for the Removal of Heavy Metal Ions.

Preparation of modified multiwalled carbon nanotubes (l-Arg-CS/MWCNTs-COOH/Fe3O4) as sorbent for dispersive solid phase extraction of Cu(II), Pb(II) and Cd(II) in wastewater samples

Novel amidinothiourea-modified chitosan microparticles for selective removal of Hg(II) in solution

Selective Adsorption and Determination of Hexavalent Chromium in Water Samples by Chemically Modified Activated Carbon with Tris(hydroxymethyl)aminomethane

Preparation of a high pH-resistant AAPTS-silica coating and its application to capillary microextraction (CME) of Cu, Zn, Ni, Hg and Cd from biological samples followed by on-line ICP-MS detection

Preconcentration, separation and determination of trace Hg(II) in environmental samples with aminopropylbenzoylazo-2-mercaptobenzothiazole bonded to silica gel

Simultaneously-efficient electro-sorption of Pb(II), Cu(II) and Cd(II) by Cu 2+ modified superactive carbons

An ion-imprinted functionalized silica gel sorbent prepared by a surface imprinting technique combined with a sol-gel process for selective solid-phase extraction of cadmium(II)

Solid-phase extraction using multiwalled carbon nanotubes and quinalizarin for preconcentration and determination of trace amounts of some heavy metals in food, water and environmental samples

Combined cation-exchange and extraction chromatographic method of pre-concentration and concomitant separation of Cu(II) with high molecular mass liquid cation exchanger after its online detection

Efficient removal of Cu(II) from an aqueous solution using a novel chitosan assisted EDTA-intercalated hydrotalcite-like compound composite: Preparation, characterization, and adsorption mechanism

Ultrasound assisted magnetic solid phase extraction of copper(II) and lead(II) in environmental samples on Magnetic Activated Carbon Cloth