Abstract:This paper strives to derive the analytical solutions for the dynamic analysis of stepped multi-span rotor system, where the rotating shaft's internal damping effect is also considered. Specifically, the steady-state whirl analysis and free vibration analysis is given herein. For the steady-state whirl analysis, firstly, the stepped shaft is spilt to several uniform segments and their governing equations are established by Hamilton principle. Subsequently, by applying variable separation method and Laplace transform method to each segment's governing equation, their steady-state responses in terms of determinate interpolation functions multiplied by unknown boundary constants are derived. Then based on the transfer matrix method, each segment's boundary constants are determined with consideration of the compatibility conditions of each two adjacent segments and the end boundary conditions. For the free vibration analysis, one only need to remove the forced term in the steady-state form of transfer matrix and the rotor's characteristic equation will be obtained. Through the theoretical derivation, it is found that this analytical approach can be generalized to any isotropic elastic boundary conditions. To validate the proposed method, two case studies are proposed, where the finite element method is used as benchmark method. For the first one, the influence of internal damping on a uniform rotor's damped whirl characteristics and its stability is analyzed. The damped whirl characteristics analysis reveals that viscous internal damping result in the destabilization of forward modes as long as the spinning speed becomes higher than the critical speed. This phenomenon is also demonstrated by the time responses analysis. For the second one, the dynamic responses of a two-span three steps rotor-bearing system with isotropic viscoelastic boundary conditions are determined. All of simulated results show a great agreement between analytical results and FEM results.

Vibration and Stability Analysis of a Multi-stepped Shaft System of Turbo Compressor

Torsional Vibration of a Shafting System under Electrical Disturbances

Analysis of Flexural and Torsional Vibration for Turbogenerator Shafts on Power Impact

Vibration Analysis of a Nonlinear Rotor-Bearing-seal System

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

The Vibration Characters Analysis of Tube Compressor

STABILITY ANALYSIS OF THE SHAFT TORSIONAL OSCILLATION BASED ON LYAPUNOV DIRECT METHOD

Modeling and Performance Analysis of Rotary Compressor Considering Multi-Body Coupling and Bearing Deformation

Analytical approach to the stepped multi-span rotor-bearing system with isotropic elastic boundary conditions

Dynamic stability analysis of a high-speed diesel engine turbocharger subjected to aerodynamic loads and engine-induced vibration

Dynamic analyses for the rotor-journal bearing system of a variable speed rotary compressor

Computational Analysis of Nonlinear Dynamics of a Multi-disk Rotor-Bearing-Brush Seal System

Solution for the Torsional Vibration of the Compressor Shaft System with Flexible Coupling Based on a Sensitivity Study

Modal and vibration analysis of reciprocating compressor crankshaft system

Small-signal Modeling and Modal Analysis of Wind Turbine Based on Three-mass Shaft Model

Small Signal Stability Analysis of Wind Turbine for Shaft Torsional Vibration Studies

Analysis of Dynamic Characteristics of the Main Shaft System in A Hydro-Turbine Based on Ansys

Torsional Vibration Analysis for Large-Scale Reciprocating Compressor Crankshaft

Stability and modal analysis of an unbalanced asymmetric multi-disk rotor system on bearings as viscoelastic substrate

Multibody Dynamic Analysis of a Wind Turbine Drivetrain in Consideration of the Shaft Bending Effect and a Variable Gear Mesh Including Eccentricity and Nacelle Movement

Numerical Research on Dynamic Lateral Vibration of a Pump Turbine’s Shaft System