Abstract:It is of significant theoretical and practical value to study the deposition process and deformation behavior of cold-sprayed particles to find the deposition mechanism of cold-sprayed coatings, further improve the coating performance, and expand its application scope. However, observing the deposition process and particle behavior through experiments is difficult due to the brief deposition duration of cold spray particles. Numerical simulation offers a means to slow the deposition process and predict the critical velocity, deformation behavior, bonding mechanism, and residual stress of cold-sprayed particles. This paper uses finite element analysis software, including ANSYS LS Dynamic-2022 R1 and ABAQUS-6.14, alongside various prevalent finite element methods for numerically simulating cold spray particle deposition. These methods involve the Lagrange, Euler, arbitrary Lagrange-Euler (ALE), and Smoothed Particle Hydrodynamics (SPH) to investigate the cold spray particle deposition process. The recent literature primarily summarizes the simulation outcomes achieved by applying these methodologies for simulating the deposition process and deformation characteristics of different particles under varying cold spraying conditions. In addition, the reliability of these simulation results is analyzed by comparing the consistency between the simulation results of single-particle and multi-particle and the actual experimental results. On this basis, these methods' advantages, disadvantages, and applicability are comprehensively analyzed, and the future simulation research work of particle deposition process and deformation behavior of cold spraying prospects is discussed. Future research is expected to provide a more in-depth study of the micro-mechanisms, such as the evolution of the inter-particle and internal organization of the particles, near the actual situation.

Numerical Simulation of Minimal Average Bonding Strength to Suppress Rebounding in Cold Spraying Cu/Cu: A Preliminary Study

Study on interface behavior of Be/CuCrZr alloy by diffusion bonding

Investigating the Cold Spraying Process with the Material Point Method

Impact velocity-dependent bonding mechanisms in metal cold spray

A Numerical Approach to Study the Oxide Layer Effect on Adhesion in Cold Spray

Correlation between the macroscopic adhesion strength of cold spray coating and the microscopic single-particle bonding behaviour: Simulation, experiment and prediction

Research Progress on Numerical Simulation of the Deposition and Deformation Behavior of Cold Spray Particles

Prediction of deformation characteristics and critical velocities during cold-spray: A new 3D model

Effect of particle oxidation, size and material on deformation, bonding and deposition during cold spray: a peridynamic investigation

Calibration of the Critical Velocity Description in Cold Spray

Simulation of Deposition Behavior of Bulk Amorphous Particles in Cold Spraying

Molecular dynamics simulations and analyzation of Cu deposited on stainless steel substrate surfaces

Tamping effect during additive manufacturing of copper coating by cold spray: A comprehensive molecular dynamics study

Strengthening Effect of Ag Precipitates in Cu–Ag Alloys: A Quantitative Approach

Measurement and analysis of cold spray residual stress using arbitrary Lagrangian–Eulerian method

Determination of Critical Velocity of Cold-Sprayed NiCoCrAlY Coating via Arbitary Lagrangian-Eulerian (ALE) Method of Finite Element Simulation

Evaluation of copper spall response using Mie-Grüneisen equation-of-state parameters determined from molecular dynamics

Hot Compression Bonding Behavior and Constitutive Model of Spray Deposited 2195 Al-Cu-Li Alloy

An experimentally validated dislocation density based computational framework for predicting microstructural evolution in cold spray process

Probing trade-off between critical size and velocity in cold-spray: An atomistic simulation

Development of a material model for predicting extreme deformation and grain refinement during cold spraying