Abstract:Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, Ahead of Print. A recent study was being conducted to offer a three-dimensional numerical inspection of the water–Ag/Cu nanofluids' hydrothermal profitability within a parabolic-trough solar collector incorporating a porous medium. This study aims to improve the thermal efficiency of parabolic-trough solar collectors by integrating nanofluids and porous media into the receiver tube. The focus is on enhancing heat transfer to the working fluid for better performance. In our numerical simulation, the working fluid of water (or nanofluid) at 5 different mass flow rates of 20, 40, 60, 80, and 100 L/h and with a temperature of 20°C enters the receiving pipe of a parabolic-trough solar collector while the non-constant heat flux is set on it. Copper and silver nanoparticles in volume fractions of (0.1 to 0.5%) and Darcy numbers of 0.1, 0.01, and 0.001 are simulated in applied porous media. The results of the simulations revealed that the use of a porous medium with (rp = 1 and Da = 0.1) and also in mass flow rate of 20 L/h, our receiver pipe saw a 2204.8% increase in the Nusselt number and 687.8% pressure drop, and the PEC was equal to the number 11.3. In the following, we examined copper and silver nanoparticles in two cases of applying porosity and without applying porosity in the receiving tube in volume fractions of 0.1 to 0.5%. Due to the creation of a high-pressure drop by the porous medium, nanofluids showed higher numbers for the performance evaluation criterion than unity for the non-porous state. Silver nanoparticles in volume fraction of 0.5% (at rp = 1 and Da = 0.1) showed an increase of 71.3% and 197.8%, respectively, for the Nusselt number and pressure drop. In the case of non-porous copper nanoparticles with a volume fraction of 0.5%, they showcased an uptick in 217.6% and 3.8% respectively for the Nusselt number and pressure drop.

Numerical simulation of the effects of superhydrophobic coating in an oval cross-sectional solar collector with a wavy absorber filled with water-based Al2O3-ZnO-Fe3O4 ternary hybrid nanofluid

Evaluation of Wavy Direct Absorption Solar Collector (DASC) Performance Using Different Nanofluids

Numerical simulation of the performance of a novel parabolic solar receiver filled with nanofluid

Optimization of wavy direct absorber solar collector (WDASC) using Al2O3-water nanofluid and RSM analysis

Thermal Performance Evaluation of Alumina-Water Nanofluid in an Inclined Direct Absorption Solar Collector (idasc) Using Numerical Method

Numerical study on effect of hybrid nanofluid as a passive heat transfer enhancement technique and different climates on thermal performance in a linear Fresnel collector

Performance Analysis of a Minichannel-Based Solar Collector Using Different Nanofluids

Influence of Water Based Binary Composite Nanofluids on Thermal Performance of Solar Thermal Technologies: Sustainability Assessments

Enhanced heat transfer performance in a parabolic trough solar collector: A CFD investigation of silver and copper nanofluids utilizing porous medium

Thermo-Fluid Characteristics of a Flat-Plate Collector with Different Riser Tube Configurations Employing ZnO/Water Nanofluids: An Experimental and Numerical Analysis

Combined active-passive heat transfer enhancement for a partial superhydrophobic oscillating cylinder

Numerical analysis with experimental validation for thermal performance of flat plate solar water heater using CuO/distilled water nanofluid in closed loop

An Experimental Investigation of the Effect of using Non-Newtonian nanofluid- Graphene Oxide /Aqueous solution of Sodium Carboxymethyl Cellulose- on the Performance of Direct Absorption Solar Collector

Improving Environmental Performance of a Direct Absorption Parabolic Trough Collector by Using Hybrid Nanofluids

Numerical investigation on the thermal performance of parabolic trough solar collector with synthetic oil/Cu nanofluids

Utilization of H2O/CuO and Syltherm 800/CuO Nanofluids in a Concentrating Solar Collector with Photovoltaic Elements

Long-Term Performances and Technoeconomic and Environmental Assessment of Al2O3/Water and MWCNT/Oil Nanofluids in Three Solar Collector Technologies

An evaluation of heat transfer and pressure drop performance of superhydrophobic surfaced integral mini-channel heat sinks with nanofluids

Numerical investigation of forced convection flow characteristics on hydrophobic surface with nanofluid

An experimental investigation on the effect of Al2O3/distilled water nanofluid on the energy efficiency of evacuated tube solar collector

Investigation of Nanofluid Heat Transfer in a Microchannel Under Magnetic Field Via Lattice Boltzmann Method: Effects of Surface Hydrophobicity, Viscous Dissipation, and Joule Heating