Abstract:Material microstructures often contain non-uniformly distributed features of complex geometry. Attributes of three-dimensional microstructural geometry have dominant influence on the mechanical behavior of materials. Therefore, it is of interest to incorporate quantitative description of actual three-dimensional microstructures in micromechanical analysis of materials. In this contribution, a methodology has been developed to perform finite element (FE)-based simulations on complex three-dimensional microstructures, through its application to cast microstructure of A356 Al-alloy containing non-uniformly distributed pores of complex geometry. As expected, the simulations reveal that the distributions of local stresses and strains depend on size, orientation, and spatial arrangement of the pores in a complex manner. FE-simulations on the three-dimensional pore structure have been used to simulate the growth of the voids by the McClintock rule. These simulations clearly demonstrate that unit cell model can be used in the study the void growth behavior of materials at the stress levels close to global yield stress, and it overestimates the void growth at the stress levels significantly higher global yield stress. The FE-simulations reveal a general trend that larger voids have a higher percentage increase in their volume. Therefore, at a given applied stress level, absolute rate of volume change of a pore increases with its initial pore volume in a non-linear manner. These observations are supported by experimental measurements of pore growth. It is shown that micromechanical response does not vary significantly if the pores are replaced by equivalent ellipsoids, and such a model can be used to simulate the growth of non-uniformly distributed voids of complex geometry at all stress levels.

On the dependence of effective mechanical properties of ceramics on partial concentrations of different size pores in its structure

Dependences of Mechanical Properties of Ceramics with Bimodal Pore Size Distribution on the Porosity at Various Scale Levels

3D modeling of the mechanical behavior of ceramics with pores of different size

The Relationship Between Structural Features and Local Mechanical Properties of a Fine-Grained Matrix in Refractory Ceramic Materials. SiO2 Ceramics Case Study

Influence of the microstructure on the mechanical behavior of nanoporous materials under large strains

The Influence of Specimen Geometry and Loading Conditions on the Mechanical Properties of Porous Brittle Media

Towards optimized pore structure to balance the thermal-mechanical performance of foamed ceramic

Strength Analysis of Porous YSZ&nbsp;Ceramics With the Same Porosity and Different Pore Structure

MECHANICAL PROPERTIES AND OPTIMAL ANALYSIS ON VARIOUS LEVEL MICRO-COMPOUNDED CERAMIC COMPOSITE

Elastic Properties of Model Porous Ceramics

The Influence of the Volume Fraction of Ceramic Particles on the Plastic Strain Localization and Fracture of Metal Matrix Composites. Computational Analysis

Metal-ceramic materials. Study and prediction of effective mechanical properties

Elastic properties and compressive mechanical behaviour of closed-cell porous materials: Effect of microstructural morphology

Surface Effects On The Elastic Modulus Of Nanoporous Materials

Influence of Features of Interphase Boundaries on Mechanical Properties and Fracture Pattern in Metal–Ceramic Composites

Effect of pore design on the mechanical properties of nanoporous high-entropy alloys

Mechanical Properties and Pore Size Distribution in Athermal Shear-Strained Porous Glasses

Micromechanics of complex three-dimensional microstructures

Effects of porosity on the measured fracture energy of brittle materials

A novel strategy in micomechanics modeling of silica fibrous ceramics considering morphology-related sintering effects

Analytic solutions for effective elastic moduli of isotropic solids containing oblate spheroid pores with critical porosity