Abstract:Understanding field failure and degradation modes in solar photovoltaic (PV) modules is very important for various reasons especially for this widely used technology. The University of Applied Sciences Ostwestfalen-Lippe in Höxter owns photovoltaic-modules of different cell types, sizes and operation periods in German weather conditions. This paper presents a detailed degradation investigation and performance parameters analysis for chosen samples of polycrystalline, monocrystalline and thin film modules in the laboratory and outdoor test conditions after 10 years of exposure. The obtained measurements were standardized and then compared with the warranted values of the manufacturer’s datasheets for each module type. The real outdoor measurements for the larger units show that the maximum power Pmax after 10 years of exposure for polycrystalline, monocrystalline and amorphous thin film modules had declined by: 8.47%, 37.67%, and 19.05% respectively, which translates to an annual linear degradation rates of 0.652%, 3.67%, and 1.465% for each type respectively. While the maximum power output of the smaller units had declined by 19.05%, 19.36%, and 21.75% for polycrystalline, monocrystalline and amorphous thin film modules respectively, which also translated to annual linear degradation rates of 1.48%, 1.67%, and 0.6% for each type respectively. On the other hand, the laboratory tests for these modules show that there is a clear variation with the obtained outdoor results, where the Pmax for the same larger units had declined by 39.6%, 57.4%, and 82.5% for polycrystalline, monocrystalline and thin film modules respectively, While the Pmax output of smaller units had declined by 51.2%, 39.38%, and 9.39% for polycrystalline, monocrystalline and thin film modules respectively, The comparison of the efficiency and fill factor parameters for the obtained results with the manufacturer’s data shows that the outdoor measurements introduce close results than the laboratory results. The discoloration of the encapsulant is the most frequently occurring visually observable defects on the modules.

Outdoor degradation of thin film amorphous silicon based PV modules

A Comparative Investigation on Outdoor and Laboratory Test of the Degradation Rates for Different Types of Photovoltaic Modules with Different Exposure Periods

Outdoor Performance Monitoring Method for Degradation Studies of Perovskite Modules

Accelerated degradation tests of large area a-Si solar cells

Analysis of the Degradation of Monocrystalline Silicon Photovoltaic Modules After Long-Term Exposure for 18 Years in a Hot–Humid Climate in China

Hotspots and Performance Evaluation of Crystalline-Silicon and Thin-Film Photovoltaic Modules

Outdoor performance of organic photovoltaics: Diurnal analysis, dependence on temperature, irradiance, and degradation

Relation between degradation of polymeric components in crystalline silicon PV module and climatic conditions: A literature review

Performance Degradation of Crystalline Silicon Solar Module in Various Ultraviolet Radiation Area

Non-Destructive Failure Detection and Visualization of Artificially and Naturally Aged PV Modules

Performance and degradation analysis for long term reliability of solar photovoltaic systems: A review

Analysis of various degradations of five years aged mono c-Si, poly c-Si, and thin-film photovoltaic modules from rooftop solar installations in Dhaka’s tropical wet and dry climate conditions

Measuring metal halide perovskite single cell degradation consistent with module-based conditions

Performance Degradation and Reliability Evaluation of Crystalline Silicon Photovoltaic Modules Without and with Considering Measurement Reproducibility: A Case Study in Desert Area

A Fine Model of Power Degradation for Crystalline Silicon Solar Modules

In-Situ Measurement of Power Loss for Crystalline Silicon Modules Undergoing Thermal Cycling and Mechanical Loading Stress Testing

Optical degradation impact on the spectral performance of photovoltaic technology

Long‐term outdoor study of an organic photovoltaic module for building integration

Current Status of Outdoor Lifetime Testing of Organic Photovoltaics

Degradation analysis of field-exposed photovoltaic modules with non-fluoropolymer-based backsheets

From performance measurements to molecular level characterization: Exploring the differences between UV and DH weathering of PV modules