Abstract:Iron ore pellet reduction experiments were performed with pure hydrogen (H2) and mixtures with carbon monoxide (CO) at different ratios. For direct reduction processes that switch dynamically between reformed natural gas and hydrogen as the reductant, it is important to understand the effects of the transition on the oxide reduction kinetics to optimize the residence time of iron ore pellets in a shaft reactor. Hence, the reduction rates were studied by varying experimental parameters such as the temperature (800, 850 & 900 °C), reactant gas flow rate (100, 150 & 200 cm3/min), pellet size and composition of the reactant gas mixture. The rate of reduction was observed to increase with an increase in temperature and reactant gas flow rate, but it decreased with an increase in pellet size. SEM greyscale analysis was performed to analyze the porosity and phase composition of partially reduced pellets. The porosity of the pellets was observed to increase from 0.3 for unreacted pellet to 0.42 for a completely reduced pellet. Energy-dispersive X-ray spectroscopy (EDAX) analysis was performed to identify the phases observed in the SEM images. The fraction of iron phase was observed to increase from the shell region of the pellet to the core region with an increase in the degree of reduction. A 2D-axisymmetric numerical model was developed on COMSOL Multiphysics, and it was validated using the conversion (X) vs. time curves obtained from each experiment. The model was able to accurately predict the total time needed for the complete conversion of a single iron ore pellet for multiple experiments. Effects of changes in the porosity and tortuosity of the pellet on the model were also studied and the rate of reduction was observed to be sensitive to changes in both porosity and tortuosity. The SEM analysis and the model results show that tortuosity is higher for pellets reduced with H2 than for pellets reduced with H2-CO gas mixtures.

Numerical Simulation of Flash Reduction of Iron Ore Particles with Biomass Syngas

Numerical Simulation of the Effect of Feeding Mode on the Reduction of Ore Powder in Hydrogen‐Based Flash Ironmaking Process

Effects of Biomass Properties on Hematite Flash Reduction-Biomass Steam Gasification Coupling Process

Direct reduction of iron-ore with hydrogen in fluidized beds: A coarse-grained CFD-DEM-IBM study

Numerical Analysis of Flash Ironmaking Process in a Newly Proposed Counter-Current Downer

Computational Study of Hot Gas Injection (HGI) into an Ironmaking Blast Furnace (BF)

Numerical Investigation of the Limit of Coke Rate Reduction in an Ironmaking Blast Furnace (BF)

Wall Reduction and Heat Transfer Characteristics of Captured Iron Ore Particles During Flash Ironmaking Process

Experimental and Numerical Simulation Study on Reduction of Pellets Based on X-ray Micro-computed Tomography

Numerical Analysis of the Dust Control Performance of a Counter-current Swirling Configuration in the Flash Ironmaking Reactor

Kinetic Study of Iron Ore Fines Reduction in Circulating Fluidized Bed

Insights into direct reduction iron using bamboo biomass as a green and renewable reducer: Reduction behavior study and kinetics analysis

Study of Smelting Reduction Iron Coupled with Pulverized Coal Gasification to Produce High-Concentration Syngas

Modeling Isothermal Reduction of Iron Ore Pellet Using Finite Element Analysis Method: Experiments & Validation

Numerical Study of the Reduction Process in an Oxygen Blast Furnace

Numerical Simulation of Sintering Based on Biomass Fuel

Mathematical Modeling for the Process of Smelting Reduction Ironmaking Integrated with Hydrogen-Rich Coal Gasification

Direct Reduction Ironmaking by Co-Pyrolysis of Biomass Tar Model Compounds and Iron Ore Fines

Thermodynamic evaluation for reduction of iron oxide ore particles in a high temperature drop tube furnace

Reduction Kinetics of Fine Hematite Ore Particles with a High Temperature Drop Tube Furnace

A Numerical Study of the Thermochemical and Aerodynamic States of H2‐intensive Direct Reduction Shaft Furnace