Abstract:In this research, the mechanical behaviors of extruded AZ31B Mg plate along normal direction (ND) were investigated over a wide range of strain rates. High strain rate tests were carried out using a split Hopkinson pressure bar at room temperature. The corresponding deformation mechanisms, texture evolution and microstructure changes were analyzed by utilizing optical microscope (OM), X-ray diffraction (XRD), electron backscatter diffraction (EBSD) and transmission electron microscopy (TEM). It is found that the mechanical responses exhibit both sigmoidal hardening and power-law hardening behaviors under compression at high strain rate ranges of 1068-5647 s(-1). The prismatic type textures of the skin layer and center layer of the AZ31B plate determine its mechanical behaviors. The sigmoidal hardening behaviors are resulted from the formation and development of {10-12} extension twinning at the initial stage of deformation. Whereas the power-law hardening behaviors are resulted from non-basal < c+a > dislocation slip dominated the deformation at the initial deformation stage. Experimental results indicate the critical resolved shear stress (CRSS) for extension twinning and non-basal < c+a > dislocation slip are insensitive to strain rate, but the latter CRSS is significantly higher than the former CRSS. The flow stress is insensitive to strain rate if plastic deformation is dominated by extension twinning, while it increases with the increase of strain rate if plastic deformation is dominated by nonbasal < c+a > dislocation slip. Dynamic recrystallization (DRX) took place if the AZ31B plate was compressed at strain ranges of 4737-5647 s(-1), resulting in a decrease in flow stress and a significant increase in ductility. (C) 2016 Elsevier B.V. All rights reserved.

Fracture Behavior of AZ31 Magnesium Alloy During Low-Stress High-Temperature Deformation

Varying strain rates and elevated temperatures effects on the mechanical properties of AZ31B magnesium alloy

Analysis of high-temperature deformation and microstructure of an AZ31 magnesium alloy

Deformation Behavior of AZ31B Magnesium Alloys with Different Process States under Thermal Compression

The Elevated-Temperature Mechanical Behavior of Peak-Aged Mg–10Gd–3Y–0.4Zr Alloy

Microstructure Evolution and Creep Behavior of High-Pressure Die-Cast Mg–9Al–1Zn–1Sr Alloy

Mechanical properties and failure behavior of AZ61 magnesium alloy at high temperatures

Tensile creep behaviors of Mg-10Gd-0.4Zr alloy under the different applied stresses at 260 °C

Fracture Mechanism of Magnesium Alloys at Room Temperature

Creep and Fracture Behavior of Peak-Aged Mg-11y-5gd-2zn-0.5zr (wt Pct)

High Temperature Deformation Behavior of Fine-Grained AZ31 Magnesium Alloy

Temperature Dependency on the Microscopic Mechanism in the Normal Direction of Wrought AZ31 Sheet under Dynamic Compressive Behavior

Deformation behavior and microstructure transformation of AZ31B Mg alloy under high strain rate compression

Hot Deformation Behavior of AZ91 Magnesium Alloy in Temperature Ranging from 350°C to 425°C

Strain Rate and Temperature Effects on Formability and Microstructure of AZ31B Magnesium Alloy Sheet

Creep and fracture behavior of as-cast Mg–11Y–5Gd–2Zn–0.5Zr (wt%)

High-Temperature Creep Behavior of Mg-9Gd-2Nd-1Ca-0.5Zr Alloy

Dynamic mechanical response and microstructural evolution of extruded Mg AZ31B plate over a wide range of strain rates

Deformation Behavior of Az80 Wrought Magnesium Alloy at Cryogenic Temperatures

Creep Behaviors and Microstructure Evolution of Mg-5Y-2Nd-3Sm-0.5Zr Alloys

Time-dependent uniaxial behavior of rolled magnesium alloy AZ31B at 393 K and room temperature