Abstract:This work deals with basic interactions of additives during the crosslinking process of ethylene‐vinyl acetate copolymer (EVA) at different lamination temperatures. The influence of the used contents of crosslinking peroxides and crosslinking accelerators on the achieved gel content was comprehensively investigated. The three‐dimensional crosslinking of encapsulants in photovoltaic (PV) modules significantly defines their thermomechanical properties and is usually initiated using peroxides and crosslinking accelerators. However, it has been shown that excess peroxides lead to undesirable side reactions such as browning, which is directly linked to the PV module power losses. Therefore, the encapsulant formulation should be adjusted accordingly, on the one hand, keeping the peroxide concentration possibly low and, on the other hand, enabling a sufficiently high gel content (GC). This work investigates the basic interaction of the crosslinking peroxide Luperox TBEC and the crosslinking accelerator Perkalink 301 (TAIC) with differential scanning calorimetry (DSC), to address this issue. In addition, their reaction potential with the antioxidant butylhydroxytoluene (BHT) is investigated. It is shown that stabilizing additives can have an influence on the peroxide crosslinking process, which can affect the resulting crosslinking state and require optimization of the lamination conditions. The additive content of commercial PV encapsulants is quantified using pyrolysis gas‐chromatography mass spectrometry (PY‐GCMS). Subsequently, a number of films with different TBEC and TAIC contents are produced, and their GC is analyzed as a function of the additive concentrations and lamination conditions. A range of formulations leading to a GC > 75% was identified which can be used as a guidance for encapsulant manufacturers.

Encapsulation of PV Modules Using Ethylene Vinyl Acetate Copolymer as the Encapsulant

Progress of the Encapsulants for Photovoltaic Modules

Design for optimal one-dimensional surface profile of EVA on solar cell modules

Early‐stage identification of encapsulants photobleaching and discoloration in crystalline silicon photovoltaic module laminates

Properties and degradation behaviour of polyolefin encapsulants for photovoltaic modules

Vinyl-Functionalized Polyolefins for Fast Photovoltaic Cell Encapsulation

A research review on the encapsulants with high transmittance character

Polar Wax as Adhesion Promoter in Polymeric Blend Films for Durable Photovoltaic Encapsulants

Crosslinking Behavior of Ethylene‐Vinyl Acetate Copolymer Encapsulants in Dependence of the Additive Composition

Encapsulant Materials and Their Adoption in Photovoltaic Modules: A Brief Review

Encapsulation of commercial and emerging solar cells with focus on perovskite solar cells

Novel EPE co-extruded encapsulating films with UV down-conversion power gain effect for highly efficient solar cells

Recent developments of polymer-based encapsulants and backsheets for stable and high-performance silicon photovoltaic modules: materials nanoarchitectonics and mechanisms

Enhancing photovoltaic modules encapsulation: Optimizing lamination processes for Polyolefin Elastomers (POE) through crosslinking behavior analysis

First principles modeling of polymer encapsulant degradation in Si photovoltaic modules

Composite material with enhanced recyclability as encapsulant for photovoltaic modules

Lower LCOE achievement of silicon heterojunction solar modules with low water vapor transmission rate encapsulants

Influence of Fragment Size on the Time and Temperature of Ethylene Vinyl Acetate Lamination Decomposition in the Photovoltaic Module Recycling Process

Effective decapsulation method for photovoltaic modules: Limonene-induced EVA controlled swelling under sonication and debonding mechanism analysis

Effect of crosslinking on EVA-based encapsulant properties during photovoltaic module fabrication process

Chemical and mechanical interfacial degradation in bifacial glass/glass and glass/transparent backsheet photovoltaic modules