Injection Studies on a Small-Scale Rotating Detonation Engine

Jonathan J. Wyatt,Nathan J. Snow,Nathan T. Fiorino,Frederick R. Schauer,Marc D. Polanka,Brian Sell,Kevin Y. Cho
DOI: https://doi.org/10.2514/6.2022-1114
2022-01-03
Abstract:View Video Presentation: https://doi.org/10.2514/6.2022-1114.vid The Rotating Detonation Engine (RDE) has gained increasing attention in recent years for its potential advantages over typical deflagration combustion. A Micro-RDE design with an outer diameter of 28mm operating on Nitrous Oxide and Ethylene was recently developed, which stretched the limits of small-scale detonation engines. The testing on this rig has shown a stable one wave mode detonation with frequencies reaching 16.8 kHz. Key parameters that influence the detonation wave mode are cell size, fill height, and wave speed, which are heavily influenced by injection schemes. Previous testing utilized a partially-premixed jets in crossflow (JIC) injection scheme, while tests before that used a traditional JIC scheme. A simplex and counter-jet injection scheme were added to the configuration to explore other options of injecting the fuel and oxidizer. The goal of this research was to characterize the operating limits of the injection schemes and understand their effects on the detonation wave stability in a small-scale RDE. The traditional JIC scheme produced the largest operating map detonating at oxidizer mass flow rates from 55 g/s to as low as 12 g/s. However, its average wave speed, 1106 m/s, was lower compared to the Chapman-Jouget detonation speeds than some other results, Testing with the simplex injection scheme resulted in wave speeds averaging 1167 m/s and produced the most limited operating map as detonations in this configuration only detonated at fuel rich equivalence ratios. The partially-premixed JIC produced higher wave speeds reaching an average 1490 m/s while achieving a lower limit of 45 g/s. The highest wave speeds of 1518 m/s were achieved for a specific configuration of the offset counter-jet injection configuration over a limited set of conditions.
What problem does this paper attempt to address?