Measurement of the electron density in Transient Spark discharge
Mário Janda,Viktor Martišovitš,Karol Hensel,Lukáš Dvonč,Zdenko Machala
DOI: https://doi.org/10.1088/0963-0252/23/6/065016
2014-09-04
Plasma Sources Science and Technology
Abstract:This paper presents our measurements of the electron density in a streamer-to-spark transition discharge, which is named transient spark (TS), in atmospheric pressure air. Despite the dc applied voltage, TS has a pulsed character with short (∼10–100 ns) high current (>1 A) pulses, with a repetition frequency on the order of kHz. The electron density ne ∼ 1017 cm−3 at maximum is reached in TS with repetition frequencies below ∼3 kHz, using relatively low power delivered to the plasma (0.2–3 W).The temporal evolution of ne was estimated from the resistance of the plasma discharge, which was obtained by a detailed analysis of the electric circuit representing the TS and the discharge diameter measurements using a fast intensified charge-coupled device (iCCD) camera. This estimate was compared with ne calculated from the measured Stark broadening of several atomic lines: Hα, N at 746 nm, and O triplet at 777 nm. Good agreement was obtained, although the method based on the plasma resistance is sensitive to an accurate determination of the discharge diameter. We have found that this method is also limited for strongly ionized plasmas. On the other hand, a lower ne detection limit can be obtained by this method than from the Stark broadening of atomic lines.
physics, fluids & plasmas