Abstract:Impingement on blade surface by fine particles with high velocity is commonly seen in steam turbines, gas turbines and compressors, which affect the service life and reliability of the equipment. Study on particles’ rebound characteristics is of great significance to reduce the blade erosion and to control particle trajectory. Based on the nonlinear explicit dynamics analysis software ANSYS/LS-DYNA, the impacts of fine spherical particles with different diameters (20 to 500μm) on a typical martensitic stainless steel (AISI 403) target with high velocity (50 to 250m/s) have been systematically studied. The influences of incident velocities, impact angles, particles sizes on its rebound characteristics, relative impact depth, and relative dissipated energy have been analyzed. Results show that velocity restitution coefficient e decreased with the impact angle β1, the incident velocity V1, and the particle size dp. However, the role of particle size on the velocity restitution coefficient seemed to be far less than that of the other two factors. Both of particle’s tangential and normal velocity coefficient of restitution declined with the increasing impact angle in most cases. However, when the incident velocity V1 = 200m / s and the impact angle β1 > 45°, the tangential velocity restitution coefficient et of 100 μm and 200 μm particles increased with the increase in the impact angle β1. The reason might be that the relative impact depth drel was located a zone ranged from 0.1515 to 0.1677, where the tangential rebound behavior could be enhanced. Most of the variation of the tangential and normal velocity restitution coefficient along β1 decreased with the increase in the particle diameter. However, when V1 = 200m/s and β1 > 15°, the tangential reflected velocity of the larger particles was enhanced gradually. In addition, the values of the relative impact depth drel increased with the increasing impact angle and incident velocity, and it increased with the increasing particle diameter in most cases. The relative dissipated energy of particles steadily increased with the impact angle and incident velocity, respectively. Particle diameter had little effect on energy dissipation in comparison with the impact angle and incident velocity.

Energy dissipation during the impact of steel ball with liner in a tumbling ball mill

Collision and Rebound Behavior of Elastic Circular Ring Impinging on Elastic Column

Investigation of the Ball Wear in a Planetary Mill by DEM Simulation

Simulation of ball motion and energy transfer in a planetary ball mill

Energy Evolution in Complex Impacts with Friction

Measurement and calculation of impact stresses in ball mills

Influence of Steel Ball Ratio on Operation Performance of a Ball Mill Pulverizing System

Investigating the Influence of Medium Size and Ratio on Grinding Characteristics

Collision and Rebound of Ping Pong Balls on A Rigid Target

Influence of particle shape on liner wear in tumbling mills: A DEM study

Analysis on energy transfer during mechanical coating and ball milling—Supported by electric power measurement in planetary ball mill

Impact Crushing and Rebound of Thin-Walled Hollow Spheres

Dissipative properties for a ball bouncing on a vertically vibrating plate

Study on Rebound Characteristics of Fine Spherical Particles Impacting an Aisi 403 Steel with High Velocity

Factors affecting wear in tumbling mills: Influence of composition and microstructure

Energy dissipation in single ball impact on a fluid-layered specimen with the rubber and steel bed

Rolling Friction and Energy Dissipation in a Spinning Disc

Application of New Energy Saving Steel Ball Technology in Coal Mill of 300 MW Unit

Using Discrete Element Method to Analyse the Drop Ball Test

Effect of Grinding Media Grading on Liner Wear and Load Behavior in a Ball Mill by Using Rocky DEM

Impact–contact Dynamics in a Disc–ball System