Abstract:In this paper, barium titanate glass microspheres were combined with optical fiber microspheres to enhance the surface plasmon resonance (SPR) effect of the optical fiber microspheres probe, and a probe type optical fiber sensor for detection was developed. The sensor adopts a reflective structure; the light source enters the tip of the probe by a single-mode fiber to stimulate the SPR effect and then returns through the single-mode fiber, and a spectrometer monitors the change of the reflected signal. Firstly, COMSOL Multiphysics was used for simulation to verify the sensitization effect of structure optimization using barium titanate microspheres at the theoretical level. To verify the actual detection effect of the sensor, this paper uses different concentrations of sodium chloride solution for refractive index detection experiments. It makes two kinds of fiber optic sensors for comparative experiments before and after structure optimization. The experimental results show that the refractive index sensitivity of the structure before and after optimization using barium titanate microspheres is 2486 nm/RIU and 6802 nm/RIU, respectively. Combined with different functionalization methods, the sensor can be used to detect a variety of parameters. Through the chemical modification of the gold film on the sensor's surface, the detection markers were captured on the surface of the microspheres, resulting in local refractive index changes, and the qualitative and quantitative detection of different parameters was realized. Alternatively, there is great potential in diagnosing major diseases by detecting the concentrations of specific biomarkers.

SPR Microstructured D-Type Optical Fiber Sensor Configuration for Refractive Index Measurement

Refractive Index Sensors Based on Ag-metalized Nanolayer in Microstructured Optical Fibers

Surface Plasmon Resonance Sensor Based on a Novel D-Shaped Photonic Crystal Fiber for Low Refractive Index Detection

Surface plasmon resonance sensor composed of micro-nano optical fibers for high-sensitivity refractive index detection.

Determination of refractive index using surface plasmon resonance (SPR) and rigorous coupled wave analysis (RCWA) with a D-shaped optical fiber and a nano-gold grating

Surface Plasmon Resonance Optical Fiber Sensor for Refractive Index Detection Without Temperature Crosstalk

Surface Plasmon Resonance Sensor Based on D-shaped Photonic Crystal Fiber with Two Micro-Openings

High Sensitivity Fiber Optic SPR Refractive Index Sensor Based on Multimode-No-Core-Multimode Structure

Surface Plasmon Resonance Sensor for Low Refractive Index Detection Based on Microstructured Fiber

GeO2 Doped Optical Fiber Plasmonic Sensor for Refractive Index Detection

Surface Plasmon Resonance Sensor Based On Polymer Liquid-Core Fiber For Refractive Index Detection

Double-formant Surface Plasmon Resonance for Refractive Index Sensing by Anti-Resonance Fibers with High Sensitivity and Wide Detection Range

Wide refractive index detection range surface plasmon resonance sensor based on D-shaped photonic crystal fiber

Self-referencing and Calibration Microstructured Optical Fiber-Based Surface Plasmon Resonance Sensor

Design and Simulation of High-Performance D-Type Dual-Mode PCF-SPR Refractive Index Sensor Coated with Au-TiO2 Layer

Surface Plasmon Resonance Sensor Based on a D-shaped Hollow Microstructured Fiber with Bimetallic Film

Single Mode Fiber SPR Refractive Index Sensor Based on U-shaped Structure

Design and numerical analysis of a novel dual-polarized refractive index sensor based on D-shaped photonic crystal fiber

Microsphere Sensitized Fiber Optic SPR Biosensor for Refractive Index Detection

High FOM PCF-SPR refractive index sensor based on MgF 2 -Au double-layer films

Plastic Optical Fiber Based SPR Sensor for Simultaneous Measurement of Refractive Index and Liquid Level