Abstract:Different ageing treatments have been developed to achieve targeted properties in aluminum alloys through altering microstructures. However, there is a lack of understanding regarding the effect of ageing treatments on the formability of these alloys. In this study, we employed crystal plasticity finite element (CPFE) modeling, in conjunction with the Marciniak-Kuczynski (M-K) approach, to investigate the effects of ageing treatments on the mechanical properties and formability of AA6061 aluminum alloy. The as-received sheet was in the T6 heat treatment state, which was subjected to artificial ageing and pre-ageing, respectively, to achieve two age-hardened alloys with modified precipitation states. The microstructures and crystallographic textures of the three alloys were measured using the electron backscattering diffraction (EBSD) technique, and uniaxial tensile tests were performed along the rolling direction (RD), transverse direction (TD), and diagonal direction (DD, 45° to the RD) for each alloy. The forming limit curve (FLC) of the as-received alloy was determined using the Nakazima test. The dependence of mechanical strength, tensile ductility, and work-hardening behavior on the ageing treatments was clarified. Then, the tensile test results were utilized to calibrate the modeling parameters used in the CPFE model, whereas the FLC predictability of the developed model was validated with the experimental one. In the formability analysis, the effects of the ageing treatment on the FLC exhibit a notable dependency on loading paths, and the pre-aged alloy exhibits better formability than the other two at the plane strain tension state, thanks to its high work-hardening levels. In addition, the deformed textures along the different loading paths and the effects of the initial texture on the FLC are also discussed.

Influence of Aging Time on the Mechanical Properties and Bendability of 2A12 Aluminium Alloy

Effect of Stress Aging on Mechanical Properties and Microstructures of 2E12 Aluminum Alloy

Influence of aging treatment on mechanical properties of 6061 aluminum alloy

Effect of Solution Temperature and Natural Aging Period on Microstructure and Properties of Al-4Cu-2Mg-0.7Mn Sheets

Combined Effect of Pre-Strain at Elevated Temperature and Pre-Aging on Aging Strength and Microstructures of AA6082

Forming Limit for As-quenched 2A12 Aluminum Alloy

Research on the 2A11 Aluminum Alloy Sheet Cyclic Tension–Compression Test and Its Application in a Mixed Hardening Model

Aging Time on the Microstructure and Mechanical Properties of A356 Alloy by Semi-solid Processing

Influence of Aging Time on Microstructure and Mechanical Properties of Mg-8Al-1Zn-3Ca Alloy

Effect of Non-Isothermal Aging on the Mechanical Properties and Corrosion Resistance of 2A12 Aluminum Alloy

Experimental investigation and modelling of yield strength and work hardening behaviour of artificially aged Al-Cu-Li alloy

Crystal Plasticity Finite Element Analyses on the Formability of AA6061 Aluminum Alloy with Different Ageing Treatments

Microstructure and Mechanical Properties of Free-cutting 2011 Aluminum Alloy

Effect of ageing treatment process on the microstructure development and mechanical properties of 6082 Al alloy

Effect of Aging Treatment on Microstructure and Mechanical Properties of As-Extruded AA6063 Aluminum Alloy

Effect of Aging Treatment on High Temperature Mechanical Properties of a Cast Al–Li–Cu Alloy

Effect of mechanical properties, microstructure and residual stress on the bending springback behavior of high-strength Al–Mg–Si–Cu alloy tubes

Investigation of formability of aluminum alloy sheet at elevated temperature

Forming of 2A12 Aluminum Alloy Double Curvature Thin-Wall Part Based on the Hill (1948) Anisotropic Yield Criterion

Effect of Bending Forming on Fatigue for A6N01 Aluminum Alloy

Microstructures and Mechanical Properties of Age-Formed 7050 Aluminum Alloy