Abstract:The electrochemical discharge machining (ECDM) is an advanced and promising technology for fabricating micro structures. This method is effectively applicable for non-conductive hard and brittle materials micromachining, such as glass and ceramics. However, the ceramics high melting point and intense heat exchange effects during microchannel fabrication lead to the easy dissipation of thermal energy and the difficulty in processing. To address this issue and expanded the ECDM processing range. This paper dedicated to the investigation of the material removal mechanism and process characteristics for the alumina ceramic surfaces microchannels preparation. Firstly, this study explained the difference of the ECDM critical applied voltage and gas film generation mechanism by analyzing the volt-ampere characteristic curve of 20 wt% NaOH electrolyte with a tool immersed depth of 2 mm and 10 mm respectively. Then, a thermal removal finite element model (FEM) for ECDM was developed. The heat cumulative and intermittent cooling effects applied on the alumina ceramic surface dominated the materiel removal. Additionally, it can be found that the microchannel machining accuracy and bottom surface quality depended on the Gaussian heat source characteristics, gas film formation mechanism, heat accumulation effect, and temperatures spatial and temporal distribution. And a series of single factor experiments for evaluating the parametric studies such as the effect of discharge frequency, applied voltage, duty ratio and tool feed rate on the fabricated microchannel performance are executed. Finally, the complex three-dimensional structures of cross microchannel grid and zigzag microchannel array with variable depth were successfully fabricated on aluminum oxide ceramic surface. Notably, the results highlighted and enriched the ECDM stability, consistency and applicability for alumina ceramic surface microchannel fabrication.

Improvement of Surface Quality and Machining Depth of μ-ECDM Performances Using Mixed Electrolyte at Different Polarity

Enhancing the borosilicate glass micromachining by using mixed alkaline electrolytes in the ECDM process

Improvement in performance during micromachining of borosilicate glass with temperature-stirring-assisted ECDM

On the Machinability and Formation of Gas Film Thickness in ECDM of Silica based Pyrex Glass

An investigation of energy utilization behavior on borosilicate glass through heating and stirring of the electrolyte in electro-chemical discharge machining

Modelling Studies of Rotary Magnetic Field in ECDM for Microchannel Fabrication of Silica Glass

Microchannel Fabrication on Silica Glass and Experimental Investigation of MHD Convection in ECDM Process

Computational modelling and experimental investigation of micro-electrochemical discharge machining by controlling the electrolyte temperature

Electrochemical discharge machining of microchannels in glass using a non-Newtonian fluid electrolyte

Experimental and numerical analysis of pulsed-electrochemical discharge process with electrolyte stirring

Selection and Optimization of Electrolyte for Micro Electrochemical Machining on Stainless Steel 304

Optimization of Rotary-Magnet assisted ECSM on borosilicate-glass using machine learning

Deionized Water Electrochemical Machining Hybridized with Alumina Powder Polishing for Microcavity of M-333 Mold Steel

Sinking ECDM micro-milling of micro-channels with a customized electrode

Experimental and numerical investigations into the fabrication of alumina ceramic surface microchannel by electrochemical discharge machining

Electrochemical discharge machining of a high-precision micro-holes array in a glass wafer using a damping and confinement technique

A Hybrid Process of Electrochemical Discharge Machining (ECDM) and High-Speed Milling (HSM) on Quartz Glass

Machining performance enhancement of deep micro drilling using electrochemical discharge machining under magnetohydrodynamic effect

Improving surface integrity of micro-holes in ECDM using ultrahigh-speed rotary of tool cathode and non-water-based electrolyte

Performance improvement of electrochemical micromachining employing pulse width modulation

Synergistic roles of steady dwell tool feeding and ultrasonic vibrations in electrochemical discharge machining of alumina