Abstract:In this paper, aluminium chloride crystal was used as precursor to prepare silica-alumina aerogel support by sol gel method, and the active component K2CO3 was supported on the aerogel support by incipient-wetness impregnation method to obtain a modified potassium-based adsorbent. CO2 adsorption experiment was performed on the adsorbent under different reaction conditions using a small fixed-bed reactor self designed. Based on the characterization results of low temperature N-2 adsorption-desorption experiments and scanning electron microscopy, CO2 adsorption characteristics of modified potassium-based adsorbents were studied. The prepared silica-alumina aerogel support has good microstructure and uniform pores with specific surface area and pore volume are 445.7517 m(2)/g and 2.3270 cm(3)/g, respectively, and the mesopores account for more than 99%. After loading, the active component K2CO3 is uniformly dispersed. Through model comparison, it was determined that the shrinking core model and Avrami fractional kinetic model were used to fit the experimental results in order to study the reaction kinetics and adsorption kinetics. The results show that as the temperature rises, the amount of CO2 adsorbed by the adsorbent increases first and then decreases. The increase in temperature can improve the activity of the active site of the adsorbent and make the reversible exothermic reaction occur while the adsorbent adsorbs CO2 cannot proceed in the forward direction at the same time. According to the kinetic analysis, the control period of the surface chemical reaction is too short due to the high temperature, which caused low carbonation conversion. The optimal designed loading of modified potassium-based adsorbent, reaction temperature, water vapor pretreatment time, CO2 concentration and total gas volume were 30%, 60 degrees C, 30 min, 12.5%, and 500 mL/min, respectively.

Thermogravimetric Analysis and Chemical Kinetics for Regeneration of Sodium and Potassium Carbonate Solid Sorbents

Modified Kinetics Model of Nano CaO Reactions with CO2 in a CaO-Based Adsorbent

The Study of CaO Carbonation Reaction Kinetics of Cage-like Nano-CaO based CO2Sorbents

A Kinetic Model of Nano‐cao Reactions with CO2 in a Sorption Complex Catalyst

Advances in calcium carbonate thermal decomposition

The decomposition kinetics of the SiO2 coated nano-scale calcium carbonate

Study on the non-isothermal decomposition kinetics of AlOOH coated calcium carbonate

Kinetic Analysis of an Anion Exchange Absorbent for Co2 Capture from Ambient Air

Hydrothermal decomposition of glucose and fructose with inorganic and organic potassium salts.

Experimental Investigation and Kinetic Modeling of Potassium Alum Dodecahydrate Thermal Decomposition

Application of Non‐Arrhenius Equations in Interpreting Calcium Carbonate Decomposition Kinetics: Revisited

Effect of K2CO3·1.5H2O on the Regeneration Energy Consumption of Potassium-Based Sorbents for CO2 Capture

Comparative Kinetic Analysis of CaCO3/CaO Reaction System for Energy Storage and Carbon Capture

Study on Thermal Decomposition Kinetics of the Potassium Oxalate Monohydrate

Experiment and Kinetic Model Study on Modified Potassium-Based CO2 Adsorbent

CO2 Capture Exploration on Potassium Hydroxide Employing Response Surface Methodology, Isotherm and Kinetic Models

Non-isothermal Decomposition Reaction Kinetics of the Magnesium Oxalate Dihydrate

Decomposition kinetics study of AlOOH coated calcium carbonate

The evaluation of kinetic parameters from thermogravimetric data: comparison between established methods and the general analytical equation

Thermodynamics and Regeneration Studies of CO2 Adsorption on Activated Carbon

Model-Free Kinetic Determination Of Pre-Exponential Factor And Reaction Mechanism In Accelerating Rate Calorimetry