Abstract:Electrochromic niobia (Nb205) coatings were prepared by the sot-gel spin-coating and d.c. magnetron sputtering techniques. Parameters were investigated for the process fabrication of sol-gel spin coated Nb205 films exhibiting high coloration efficiency comparable with that d.c. magnetron sputtered niobia films. X-ray diffraction studies (XRD) showed that the sot-gel deposited and magnetron sputtered films heat treated at temperatures below 450°C, were amorphous, whereas those heat treated at higher temperatures were slightly crystalline. X-ray photoelectron spectroscopy (XPS) studies showed that the stoichiometry of the films was Nb205. The refractive index and electrochromic coloration were found to depend on the preparation technique. Both films showed low absorption and high transparency in the visible range. We found that the n, k values of the sot-gel deposited films to be lower than for the sputtered films. The n and k values were n = 1.82 and k = 3 × 10−3, and n = 2.28 and k = 4 × 10−3 at 530 urn for sot-gel deposited and sputtered films, respectively. The electrochemical behavior and structural changes were investigated in 1 M LiC104/propylene carbonate solution. Using the electrochemical measurements and X-ray photoelectron spectroscopy, the probable electrode reaction with the lithiation and delithiation is Nb2O5 + x Li+ + x e− ↔ LixNb205. Cyclic voltametric (CV) measurements showed that both Nb205 films exhibits electrochemical reversibility beyond 1200 cycles without change in performance. “In situ” optical measurement revealed that those films exhibit an electrochromic effect in the spectral range 300 < λ < 2100 nm but remain unchanged in the infrared spectral range. The change in visible transmittance was 40% for 250 nm thick electrodes. Spectroelectrochemical measurements showed that spin coated films were essentially electrochemically equivalent to those prepared by d.c. magnetron sputter deposition.

Electrochromic characteristics of niobium-doped titanium oxide film on indium tin oxide/glass by liquid phase deposition

Electrochromism of titanium oxide thin films

Electrochemical and Electrochromic Properties of Niobium Oxide Thin Films Fabricated by Pulsed Laser Deposition

Fabrication of electrochromic TiO2:Nb films by ultrasonic spray pyrolysis

Improvement of Electrochromic Performance by Embedding ITO Nanocrystals in Amorphous WO3 Film

Microstructures and Properties of N-Doped TiO_2 Films Grown by Dielectric Barrier Discharge Chemical Vapor Deposition

The Role of Nanoscale Seed Layers on the Enhanced Performance of Niobium doped TiO2 Thin Films on Glass

Optical and electrochemical characteristics of niobium oxide films prepared by sol-gel process and magnetron sputtering A comparison

Controllable Formation of (004)-Orientated Nb:TiO2 for High-Performance Transparent Conductive Oxide Thin Films with Tunable Near-Infrared Transmittance.

Characterization and application of niobium-doped titanium dioxide thin films prepared by sol–gel process

Electrical and optical properties of titanium nitride coatings prepared by atmospheric pressure chemical vapor deposition

Fabrication of TiO2: Nb array films and their enhanced electrochromic performance

Niobium Tungsten Oxides for Electrochromic Devices with Long-Term Stability

Electrochromic Properties of Porous NiO Thin Films Prepared by a Chemical Bath Deposition

One-Step Fabrication Of Nanostructured Nio Films From Deep Eutectic Solvent With Enhanced Electrochromic Performance

High durable TiO2 electrochromic films by Ni doping

Co-Doped Nio Nanoflake Array Films With Enhanced Electrochromic Properties

Electrochromic coloration of single-layer ITO:Nb oxides thin film

High-performance tungsten-niobium bimetallic oxide films with designable electrochromic properties

Enhancement of electro-optic properties in liquid crystal devices via titanium nanoparticle doping

Structural and Optoelectrical Properties of Nb-TiO2 Films Fabricated by Low-Energy Magnetron Sputtering and Post-Annealing