Abstract:Sorptivity (S) has been defined in terms of the horizontal infiltration equation. At unsaturated conditions (at a very short time) S represents “maximum sorption capacity”, but in saturated conditions the sorption capacity decreases with the time. Over a long time of infiltration, sorptivity was not studied as a soil water parameter that could be determined. The purpose of this study is to apply derived equations depending on the infiltration functions to predict (1) soil water sorptivity (S) at infiltration capacity ( unsaturated conditions ) and at basic infiltration rate (I b ) ( saturated conditions ), (2) the hydraulic conductivity (Saturated Ks and unsaturated K (θ ) ) into capillary-matrix and non-capillary macro pores of soils. Five alluvial (saline and non-saline clay) and calcareous soil profiles located in the Nile Delta were investigated for applying the assumed equations. A decrease in S value was observed with an increase in soil water content. At steady infiltration rate (I b ), S decreased from 1.04 to 0.647cm.min -0.5 (i.e. S decreased by 37.79%) in average in calcareous soils and from 0.537 to 0.251cm.min -0.5 (53.25%) in alluvial clay soils. The steady S w parameter was used in prediction of the hydraulic conductivities and the basic infiltration rate I b , whereas, S w is a suggested term at steady infiltration rate. The calculated values of I b were corresponding to those obtained by infiltration experiment. This confirmed the significance of steady S w as a new functional infiltration parameter. A matching factor u was calculated as a ratio between predicted I b and the measured saturated hydraulic conductivity, Ks. The mean values of u were 0.895, 0.685 and 0.360 for calcareous, clay and saline clay soils respectively. Unsaturated K (θ ) has been discriminated into saturated macro-pore K (θ ) RDP and matrix unsaturated K (θ ) h . The values of K( θ ) RDP for macro pores remained higher than those for soil matrix pores (K (θ ) h ) in the studied soils. The highest value of K (θ ) was obvious in calcareous soil profiles, while the lowest value was existed in saline clay soil. In conclusion, the predicted values of hydraulic conductivities of soil matrix (capillary) and macro (non-capillary) pores were reasonable and existed in the normal ranges of the investigated soils, indicating that the proposed equations are applicable and can be recommended to be used in coarse and fine textured soils with large scale of different properties.

Predicting Hydraulic Conductivity for Flexible Wall Conditions Using Rigid Wall Permeameter

Standard exploration of permeability coefficient test for clay by HCA

Long-term hydraulic conductivity of compacted clay permeated with landfill leachates

Calculation of Clay Permeability Using a Rectangular Particle-Water Film Model by the Double-Scale Asymptotic Expansion Method

Effect of Traffic Load on Permeability of Remolded Kaolin

Estimating Hydraulic Conductivity of Naturally Sedimented Clays Using Compression Curves

Factors affecting measurement of hydraulic conductivity in low-strength cementitious materials

Hydraulic Conductivity of Reconstituted Clays Based on Intrinsic Compression

Change of hydraulic conductivity during compression of undisturbed and remolded clays

Experimental Study on the Effect of Soil Saturation on the Electric Permeability Coefficient During Electroosmosis Process

Unified Determination of Relative Molecular Diffusivity and Fluid Permeability for Partially Saturated Cement-Based Materials

Application of the Darcy and Richards equations for modelling of water capillary rise in building materials

Evaluation of hydraulic conductivity through particle shape and packing density characteristics of sand–silt mixtures

Correlating the Chloride Diffusion Coefficient and Pore Structure of Cement-Based Materials Using Modified Noncontact Electrical Resistivity Measurement

Study on Relationship Between Dielectric Constant and Water Content of Rock-Soil Mixture by Time Domain Reflectometry.

Hydraulic conductivity and sorptivity at unsaturated and saturated conditions as related to water infiltration in soils

Exploration of PERMIT Test for Determining Permeability of Concrete

Improvement of field falling-head test and determination of hydraulic conductivity using Darcy's equation

A microstructural investigation on hydraulic conductivity of soft clay

Combining two methods for the measurement of hydraulic conductivity over a wide suction range

Evaluating the accuracy of unsaturated hydraulic conductivity determined by instantaneous profile method