Abstract:This paper employed the foam scanning method to investigate the foam properties of erucamide propyl amine oxide under various conditions, including different concentrations, temperatures, mineralization levels, salts, polymers, and weak alkaline conditions. The study covered aspects such as foaming ability, foam stability, foam carrying liquid capacity, drainage rate, and foam morphology. The research results indicated that as the concentration of the surfactant increased, the foaming ability and foam-carrying liquid capacity of erucamide propyl amine oxide increased, while foam stability and drainage rate remained relatively stable. With an increase in temperature, the foaming ability, maximum carrying liquid capacity, and drainage speed gradually increased significantly, while foam stability slightly decreased. The maximum carrying liquid capacity and drainage speed of the system increased nearly nine-fold. Different levels of mineralization, salt, and sodium carbonate had little impact on the foaming ability and foam stability of the foam system but increased the foam carrying liquid capacity and drainage rate. At the same salt concentration, the magnesium chloride system exhibited better foaming ability and foam stability but lower carrying liquid capacity and drainage rate compared to the sodium chloride system. As the temperature increased, the number of foams initially increased and then decreased, and 55°C was identified as a critical point. With the increase of time, the number of small bubbles decreased, the size of the foam increased, and the size became more uniform. The number of bubbles with a radius greater than 0.1 mm was almost unchanged with temperature increased at 200 s after N2-blowing. Therefore, erucamide propyl amine oxide exhibited excellent foam properties and demonstrated good salt and weak alkaline resistance. However, it was significantly influenced by temperature and polymers. This work provided data support for its application in the fields of daily chemicals, agriculture, medicine, and energy.

Influence of Salt Impurities on Foaming Properties of MDEA Desulfurization Solution

Grey relational analysis of contaminants governing foaming behavior in desulfurization solution for high-sulfur natural gas

The influence of different factors on the foam properties of erucamide propyl amine oxide

Effect of Sodium Dodecyl Sulfonate on the Foam Stability and Adsorption Configuration of Dodecylamine at the Gas–Liquid Interface

Molecular dynamics study of the effect of inorganic salts on the monolayer of four surfactants at the oil/water interface

Inorganic Salts as Chemical Foam Suppressors

So2 Effect On Degradation Of Mea And Some Other Amines

Effect of mixed surfactants on foam stabilization: A molecular dynamics simulation

Influence of Inorganic Salt Additives on the Surface Tension of Sodium Dodecylbenzene Sulfonate Solution

Adsorption configuration of dodecylamine at gas–liquid interface and its relationship with foam stability: MD simulation and ToF-SIMS investigation

Experimental Study of the Influence of Inorganic Salts on Foam Stability

Effects of di-ions structure of the core layer ionomer on anion exchange membrane characteristics of anti-protein fouling and electrodialysis desalination

Performance of MDEA-bicarboxylic Acid Ionic Liquid Aqueous Solutions for SO2 Capture

Microfiltration pretreatment of polymer-flooding produced wastewater before desalination: Role of Ca2+ and Mg2+ in membrane fouling

Temperature and salt resistant CO2 responsive gas well foam: Experimental and molecular simulation study

Effect of mixed anionic-nonionic reagents on flotation of diaspore and stability of froth

The effect of betaine on the foam stability: Molecular simulation

Influence of Different Types of Surfactants on the Flotation of Natural Quartz by Dodecylamine

Effect of acidic products from degradation of N-methyldiethanolamine amine on CO2/H2S capturing from natural gas

Influence of Iron and Magnesium on Fouling Properties of Organic Matter Solution in Membrane Process