Abstract:Interfacial dilational rheology is one of the important means to explore the interfacial properties of adsorption films. In this paper, the interfacial rheological properties of the mixed system of sulfobetaine ASB with a linear alkyl group and two anionic surfactants, petroleum sulfonate (PS) and alkyl polyoxyethylene carboxylate (AEC), were investigated by interfacial dilational rheology. The effect of the introduction of polymer hydrophobically modified polyacrylamide (HMPAM) on the interfacial properties of the mixed system was analyzed. In this experiment, the surfactant solution was used as the external phase and n-decane was used as the internal phase. A periodic sinusoidal disturbance of 0.1 Hz was applied to the n-decane droplets, and the changes of parameters such as droplet interfacial tension and interfacial area were monitored in real time with the help of a computer. The results show that the betaine ASB molecule responds to the dilation and compression of the interface through the change of ion head orientation, while the feedback behavior of petroleum sulfonate PS and AEC molecules embedded with oxygen vinyl groups in the molecule is diffusion and exchange between the interface and the bulk phase. Therefore, the interface film formed by ASB alone is higher, and the film formed by PS and AEC molecules alone is relatively lower. After adding two kinds of anionic surfactants to the betaine system, the ionic head of PS or AEC molecules will be attached to the positive center of the hydrophilic group of ASB molecules by electrostatic attraction and no longer adsorb and desorb with the interface deformation. The interfacial rheological properties of the compound system are still dominated by betaine, with higher dilational modulus and lower phase angle. When a small amount of HMPAM is added, or the content of hydrophobic monomer AMPS in the bulk phase is low, the intermolecular interaction at the interface is enhanced, the slow relaxation process is intensified, and the interfacial film strength is increased. As the content of AMPS further increases, hydrophobic blocks and surfactant molecules will form interfacial aggregates similar to mixed micelles at the oil-water interface, which will regulate the properties of the film by affecting the adsorption of surfactants at the interface. As long as the interfacial tension is the same, the properties of the interfacial film are the same. Based on the colloid interface science and the background of enhanced oil recovery, this study provides a reference for the field application of chemical flooding formulations.

The effect of betaine on the foam stability: Molecular simulation

Effect of mixed surfactants on foam stabilization: A molecular dynamics simulation

Molecular Array Behavior and Synergistic Effect of Sodium Alcohol Ether Sulphate and Carboxyl Betaine/sulfobetaine in Foam Film under High Salt Conditions

Stabilization of Pickering Foams by High-Aspect-Ratio Nano-Sheets

Preparation and rheological properties of a stable aqueous foam system

Structure–Behavior–Property Relationship Study of Surfactants as Foam Stabilizers Explored by Experimental and Molecular Simulation Approaches

Molecular Dynamics Simulation of the Synergistic Effect of Alkali/Surfactant/Polymer on the Formation and Stabilization of Water-Based Foam Systems

Effect of double chain anionic surfactant on the dynamic interfacial tensions of betaine solutions

Research on a synergistic formula of anionic and betaine type surfactants for natural gas fields

Enhancement of Foamability and Foam Stability Induced by Interactions Between a Hyperbranched Exopolysaccharide and a Zwitterionic Surfactant Dodecyl Sulfobetaine

The Interfacial Dilational Rheology Properties of Betaine Solutions: Effect of Anionic Surfactant and Polymer

Effect of Interfacial Properties on the Stability of Ultra-Dry CO2-in-water (C/W) Foams Stabilized with Zwitterionic Surfactants and Nonionic/anionic Polymers: Experimental and DPD Simulation

Effect of Sodium Dodecyl Sulfonate on the Foam Stability and Adsorption Configuration of Dodecylamine at the Gas–Liquid Interface

Molecular dynamics simulation study on interfacial behaviors of betaines and extended surfactants

Evaluation of the interfacial elasticity of surfactant monolayer at the CO 2 –water interface by molecular dynamics simulation: Screening surfactants to enhance the CO 2 foam stability

Dynamic interfacial tensions of sulfobetaine and polymers solutions: Effect of structures

Synergism for lowering interfacial tensions between betaines and extended surfactants: The role of self-regulating molecular size

Study of the microcharacter of ultrastable aqueous foam stabilized by a kind of flexible connecting bipolar-headed surfactant with existence of magnesium ion.

Investigations on the Influencing Mechanisms of SiO 2 Nanoparticles on Foam Stability

Experimental study of foam stability and interfacial behaviour of cellulose nanocrystals-enhanced C22-tailed zwitterionic betaine surfactant

Effect of Ph and Dodecylamine Concentration on the Properties of Dodecylamine Two-Phase Foam