Abstract:This paper presents a novel resonance-based, adaptable, and flexible inductive wireless power transmission (WPT) link for powering implantable and wearable devices throughout the human body. The proposed design provides a comprehensive solution for wirelessly delivering power, sub-micro to hundreds of milliwatts, to deep-tissue implantable devices (3D space of human body) and surface-level wearable devices (2D surface of human skin) safely and seamlessly. The link comprises a belt-fitted transmitter (Belt-Tx) coil equipped with a power amplifier (PA) and a data demodulator unit, two resonator clusters (to cover upper-body and lower-body), and a receiver (Rx) unit that consists of Rx load and resonator coils, rectifier, microcontroller, and data modulator units for implementing a closed-loop power control (CLPC) mechanism. All coils are tuned at 13.56 MHz, Federal Communications Commission (FCC)-approved industrial, scientific, and medical (ISM) band. Novel customizable configurations of resonators in the clusters, parallel for implantable devices and cross-parallel for wearable devices and vertically oriented implants, ensure uniform power delivered to the load, PDL, enabling natural Tx power localization toward the Rx unit. The proposed design is modeled, simulated, and optimized using ANSYS HFSS software. The Specific Absorption Rate (SAR) is calculated under 1.5 W/kg, indicating the design's safety for the human body. The proposed link is implemented, and its performance is characterized. For both the parallel cluster (implant) and cross-parallel cluster (wearable) scenarios, the measured results indicate: 1) an upper-body PDL exceeding 350 mW with a Power Transfer Efficiency (PTE) reaching 25%, and 2) a lower-body PDL surpassing 360 mW with a PTE of up to 20%, while covering up to 92% of the human body.

Design considerations for ultrasonic power transmission to millimeter-sized implantable microelectronics devices

Self-image-guided ultrasonic transceiver design for reliably powering mm-sized implants

Analysis and Design of a PMUT-based transducer for Powering Brain Implants

Enhancing Ultrasound Power Transfer: Efficiency, Acoustics, and Future Directions

Wireless Power Transfer Approaches for Medical Implants: A Review

Wireless Power Transfer Techniques for Implantable Medical Devices: A Review

Modeling and Measurement of an Ultrasound Power Delivery System for Charging Implantable Devices Using an AlN-Based pMUT as Receiver

Phased Array Beamforming Methods for Powering Biomedical Ultrasonic Implants

A 70%-power transmission efficiency, 3.39 Mbps power and data telemetry over a single 13.56 MHz inductive link for biomedical implants

Exploiting Spatial Degrees of Freedom for High Data Rate Ultrasound Communication with Implantable Devices

Coupling and maintaining link efficiency ultrasonics in transcutaneous energy transfer systems

An ultrasound-induced wireless power supply based on AlN piezoelectric micromachined ultrasonic transducers

A Tissue-Channel Transcutaneous Power Transfer Technique for Implantable Devices

A State of Art Review on Wireless Power Transmission Approaches for Implantable Medical Devices

Optimization of the Coupling Coefficient of the Inductive Link for Wireless Power Transfer to Biomedical Implants

A mm-sized acoustic wireless implantable neural stimulator based on a piezoelectric micromachined ultrasound transducer

A Current-Switching Communication Technique for Miniaturized Medical Implants

Developing Innovation — Wireless Transceiver Design for Implantable Medical Devices

An Optimal Design Method for Improving the Efficiency of Ultrasonic Wireless Power Transmission during Communication

Wireless Power Transmission Efficiency Improved by Conformal Phase Gradient Metasurface for Implanted Devices

Multi-Resonator Wireless Inductive Power Link for Wearables on the 2D Surface and Implants in 3D Space of the Human Body