Abstract:High quality lumbers produced from Eucalyptus plantations can be used to make higher value-added solid wood products. Moisture flow affects shrinkage, deformation, and quality of Eucalyptus wood during conventional drying. In this study, 50 and 100 mm long samples were dried using a conventional drying method. The drying curves, drying rate, moisture content (MC) gradient and distribution, moisture flow, and shrinkage during the drying process were investigated. The results show: Drying was much faster in the first 15 h for all samples and became slow as MC decreased. The drying rate above fiber saturated point (FSP) was about 3.5 times of that below FSP for all samples. The drying rate of 50 mm samples above and below FSP is 1.40 and 1.33 times of 100 mm samples; MC gradients are greater in tangential, radial directions, and cross-sections for both samples when the MC is above FSP, especially at an average MC of 50%. MC gradient along the tangential and radial direction depends on the samples size and MC stages. The short samples have much greater MC gradients than the longer samples above FSP. Moisture distributions on the cross-sections of wood coincide with the moisture gradient in the cross-sections. At an average MC of 50%, the moisture distributions of 50 mm are highly uneven, while they are relatively even in the middle of 100 mm samples, and become much more even at the end of the sample. Moisture distributions become even as MC decreases in all of the samples. Water migration directions vary by state of water. In the short samples, most free water migrates more in the fiber direction from the wood center toward the end surfaces, but bound water diffusion becomes weak. The collapse in the 50 mm samples is significantly larger than that in the 100 mm samples, indicating that the collapse is affected by the dimension of the sample.

Impact of airflow on hem-fir kiln drying

Study on the moisture uniformity of paddy drying technology by employing air direction reversals.

Optimal Design of an Angular Box for a Mixed Flow Grain Dryer

High-Pressure Treatment of Chinese Fir Wood: Effect on Density, Mechanical Properties, Humidity-Related Moisture Migration, and Dimensional Stability

Cutting power and surface quality in sawing kiln-dried, green, and frozen hem-fir wood

Optimal lamella geometry for mixed flow dryers

High-temperature drying: A review of fundamental research and development in wood drying

High temperature drying of sawn timber—A review

Modelling of Airflow Circulation Systems in Wood Drying Processes

Effect of airflow on Heat Pump in drying mode

Process Characteristics for Solar Drying Poplar Lumber

Kiln-drying effectiveness as influenced by moisture content and density variation within a Scots pine timber batch

Moisture changes and surface checking development during drying of Masson pine wood

Researching of Airflow Circulation System in Wood Drying Kiln Based on Array Fans

Experimental analysis of convective drying of paper and board

Effect of supercritical CO2 treatment and kiln drying on collapse in Eucalyptus nitens wood

Effect of the drying condition on the strength properties of Japanese larch board after vacuum heat treatment

[Effects of wind speed on drying processes of fuelbeds composed of Mongolian oak broad-leaves]

Effects of pre-steaming treatment on high-temperature and low-humidity drying characteristics of super-heavy timber with boxed-heart of Korean red pine and Douglas-fir

The Characteristics of Moisture and Shrinkage of Eucalyptus urophylla × E. Grandis Wood during Conventional Drying

Exergy analysis and optimisation of an industrial-scale circulation counter-flow paddy drying process