Abstract:Hybrid Composites, made of two different types of high strength fibre cushioned with a relatively low strength matrix to meet specific strength requirements, have been recognized as modern materials for many engineering applications. They are lightweight and low cost as compared with using a single type of fibre to make structural components, which may be over-strength and not cost-competitive. Carbon fibre is extremely strong, contributing to a thin, light but strong structure. To a certain extent, it is too costly and induces a problem of structural instability due to the decrease of second moment of inertia as compared with the use of traditional metals for designing a structure. Hybrid composites are able to minimize aforementioned problems with a low cost solution to meet the requirements. However, the design of materials and structures becomes a key challenge on how to fully utilize the benefits of these fibre to make a structure strong enough to withstand different loads imposed on it. This project aims at experimentally investigating the low-velocity impact responses of hybrid carbon/glass fibre reinforced polymer composites. It was found that a hybrid composite with surface carbon fibre layers would help minimize the risk of damage, in terms of the size of damage and deflection subject to an impact load. However, failures by impactor penetration were observed on some samples. Severe damages were found on samples with surface glass fibre layers and carbon fibre in core. Images captured by the thermography technique demonstrated that localized damages (delamination) existed within plies in a failed sample, which normally cannot be detected by using traditional visual inspection techniques.

Impact properties of flexible composites made of nylon/high-resilience non-woven fabric with an inter/intra-ply hybrid structure

Effects of needle-punched nonwoven structure on the properties of sandwich flexible composites under static loading and low-velocity impact

Low-velocity impact and static behaviors of high-resilience thermal-bonding inter/intra-ply hybrid composites

Low-velocity Impact Experiment and Analysis of Sandwich Structure Composites

Examination of Low-Velocity Impact and Mechanical Properties After Impact of Fiber-Reinforced Prepreg Composites: Low-Velocity Impact and Mechanical Properties after Impact

Impact Response of Hybrid Carbon/glass Fibre Reinforced Polymer Composites Designed for Engineering Applications

Low velocity impact response of sandwich composites with hybrid glass/natural fiber face-sheet and PET foam core

Low-Velocity Impact and Post-Impact Residual Flexural Properties of Kevlar/EP Three-Dimensional Angle-Interlock Composites

Effect of Volume Ratio and Hybrid Mode on Low-Velocity Impact Properties of Unidirectional Flax/carbon Fiber Hybrid Reinforced Polymer Composites

Investigation on manufacturing and low-velocity impact performance of all-composite sandwich structure with S-type foldcore

Investigation of Hybrid Natural Fibre Reinforced Composite for Impact Energy Absorption

Influence of hybridisation on energy absorption of 3D woven composites under low-velocity impact loading. Modelling and experimental validation

A Comparative Study on the Low Velocity Impact Behavior of UD, Woven, and Hybrid UD/woven FRP Composite Laminates

Impact and Compression-after-impact Behavior of Sandwich Panel Comprised of Foam Core and Wire Nets/glass Fiber Reinforced Epoxy Hybrid Facesheets

Low‐velocity impact properties of carbon fiber/ultrahigh molecular weight polyethylene fiber hybrid composites

Low-Velocity Impact Behavior of Foam Core Sandwich Panels with Inter-Ply and Intra-Ply Carbon/Kevlar/Epoxy Hybrid Face Sheets

Dynamic cushion, quasi-static stab resistance, and acoustic absorption analyses of flexible multifunctional inter-/intra-bonded sandwich-structured composites

Low-velocity Impact Response and Post-Impact Flexural Behaviour of Composite Sandwich Structures with Corrugated Cores

Experimental and numerical investigation of interply hybrid composites based on woven fabrics and PCBT resin subjected to low-velocity impact

GF/epoxy Laminates Embedded with Wire Nets: A Way to Improve the Low-Velocity Impact Resistance and Energy Absorption Ability

Quasi-static and dynamic mechanical responses of hybrid laminated composites based on high-density flexible polyurethane foam