Abstract:The abrasive flow machining (AFM) technique has great potentials for machining micro and complicated structures, when the specific media with both favorable fluidity and machinability are essential. In the present study, components, structures and rheological behaviors of a typical type of media were analyzed, based on with the material removal mechanism was firstly discussed. The Carreau-Yasuda model was applied for simulating the AFM process, in which the shear viscosity and relative parameters were precisely determined by analyzing the rheological behaviors of the media. The wall slipping behavior was analyzed and defined by the Generalized Navier slipping model. It was showed that the polymer melt and plasticizer oil presented similar compositions and structures, containing linear chains with few side groups, contributing to the fluidity of the media. The intense peak value in the creep curve (3.55 Pa-1) demonstrated a higher value of the viscous component than that of the elastic component, while the occurrence of saltatory regression further verified the linear structure of polymer chains. Owing to the retraction of streamlines from larger chambers into micro structures, and the combined effects of the shear stress and first normal stress difference, the polymer chains remained in stretched states, leading to uniform indentation depths and machining effects all over the machined surfaces. The flow velocity in the micro holes, which was obtained by the new simulation method, was roughly 1.5 m/s, proving that the retention time (2 x 10-3 s) was much shorter than the relaxation time of the media (230 s), indicating long-standing stretched states. The homogenous and a certain degree of shear stress, storage and loss moduli close to the inner hole surface further verified the favorable and uniform machining effects. This research is valuable for guiding the design of the media and abrasive flow machining procedures for micro structures, from aspects of either experiments or simulations.

Characterization Of Deburring By Abrasive Flow Machining for AL6061

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Towards the Determination of Machining Allowances and Surface Roughness of 3D-Printed Parts Subjected to Abrasive Flow Machining

Investigation on Finishing Mechanism and Modelling on Material Removal for Abrasive Flow Machining Micro-Channels with Asperity Surface

Abrasive flow finishing of 3D-Printed Aerofoils: Design, numerical Simulation, and experimental analysis

Study on Rheological Behaviors of Media and Material Removal Mechanism for Abrasive Flow Machining (AFM) Micro Structures and Corresponding Simulations

Machinability and Mechanism of Abrasive Flow Machining Ultra-Precision Surface with Orientated Grinding Marks

Finite Element Analysis of Burr Formation and an Automatic Online Micro-Deburring Method in Precise End-Face Grinding Process

On surface texture evolution in abrasive flow machining

Ultrasonic-assisted abrasive micro-deburring of micromachined metallic alloys

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Experimental investigation on the effet of input paramètres on surface roughness and MRR of abrasive flow machining process

Burr removal from high-aspect-ratio micro-pillars using ultrasonic-assisted abrasive micro-deburring

Particle collision-based abrasive flow mechanisms in precision machining

Deburring microparts using a magnetorheological fluid

2017A Alloy surface layer after flow burnishing with glass microspheres

Abrasive water flow polishing of superalloy microholes drilled by electrical discharge machining

Deburring Method of Aluminum Mould Produced by Milling Process for Microfluidic Device Fabrication

Research on the underlying mechanism behind abrasive flow machining on micro-slit structures and simulation of viscoelastic media

Finite Element Modeling for Orthogonal Machining of AA2024-T351 Alloy with an Advanced Fracture Criterion

Measurements of Forces and Selected Surface Layer Properties of AW-7075 Aluminum Alloy Used in the Aviation Industry after Abrasive Machining