Abstract:Hall-effect thrusters (HET) are a stationary form of electric propulsion that have been widely used in space missions. However, the wide range of the divergence angle of the HET plasma plume and the high ion velocities can result in a large area where collisions and plume interactions occur. Of these, low-energy charge-exchange (CEX) ions typically originate from collisions, and can result in severe deposition and sputtering issues on spacecraft components. In this work, we propose a novel magnetic Faraday probe in coordination with a particle-in-cell (PIC) simulation code. This system is able to deflect CEX ions with a changing solenoid current, and can be used to obtain the ion density and energy levels of CEX ions through experimental measurements. In addition, a Faraday probe, a retarding potential analyzer (RPA), and a Langmuir probe were used to obtain the beam characteristics. The CEX ion density at the beam edge area was determined to be in the level of 2.54 × 1012 m−3 (the local ion density of the plasma plume is in the level of 1013 m−3), and the ion energy level at the beam edge area was found to be below 30.1 eV. Due to the difference in the vacuum levels between ground tests and in-space operation, CEX collisions will be more severe during ground tests, and can affect plume measurements and erosion of the thruster. Two different vacuum levels were tested experimentally here to study the relationship between CEX ions and the background neutrals. As a result, it was found that a high background neutral density can exacerbate CEX collisions at the beam edge area, which results in an increase in the CEX ion density and a decrease in the CEX ion energy. This study brings us new information on the CEX ion density and energy distribution at the beam edge area from an experimental point of view. Furthermore, data on CEX ions energy can be used as input data for future plume simulations.

Electron-emission yield under electron impact of ceramics used as channel materials in Hall-effect thrusters

Atomic Investigation on the Facet‐Dependent Melting of Ceramic Nanostructures Via in Situ Electron Irradiation

Secondary Electron Emission Reduction from Boron Nitride Composite Ceramic Surfaces by the Artificial Microstructures and Functional Coating

Monte Carlo modeling of low-energy electron-induced secondary electron emission yields in micro-architected boron nitride surfaces

Effect of Electron Temperature Anisotropy on Bn Dielectric Wall Sheath Characteristics in Hall Thrusters

Effect of rectangular grooves and checkerboard patterns on the electron emission yield

Study on Sputtering Yield of Hall Thruster Discharge Chamber Wall

Study on the Erosion Phenomenon at the Bottom Channel of Magnetically Insulated Anode Cylindrical Hall Thruster

Total-Ionizing-Dose Effects on Al/SiO2 Bimorph Electrothermal Microscanners

Ion behavior in low-power magnetically shielded and unshielded Hall thrusters

Study on the Influence of Magnetic Mirror Ratio on the Erosion of the Bottom Channel of Cylindrical Hall Thruster with Magnetically Insulated Anode

Particle-in-cell simulation for effect of anode temperature on discharge characteristics of a Hall effect thruster

Measurement of the distribution of charge exchange ions in a Hall-effect thruster plume

Effect of Electron Temperature Anisotropy on Plasma-Wall Interaction in Hall Thruster

The Effect of Electron Distribution Function Anisotropy on Space Charge Saturated Sheath Critical Parameters in Hall Thrusters

Incoherent Thomson scattering measurements of electron properties in a conventional and magnetically-shielded Hall thruster

Effect of Anode Dielectric Coating on Hall Thruster Operation

Numerical Study on the Electron-Wall Interaction in A Hall Thruster with Segmented Electrodes Placed at the Channel Exit

Effect of Diamond on Sputtering Resistance Performance of Hall Thruster Channel Wall

Microstructure and Erosion Resistance of In-Situ SiAlON Reinforced BN-SiO2 Composite Ceramics

Experimental Test of 200 W Hall Thruster with Titanium Wall