Abstract:Nanostructured Ni–Fe alloy coatings were developed galvanostatically using a new low-concentration bath. The composition and operating parameters of the bath were optimised by taking the benefit of the conventional Hull cell method. Ni–Fe alloy coatings were developed at different current densities (2.0 to 5.0 A dm −2 ), keeping pH = 2.5. The corrosion behaviour of electrodeposited alloy coatings was evaluated in 3.5% NaCl solution, using Electrochemical Impedance Spectroscopy (EIS) and potentiodynamic polarisation methods. Ni–Fe alloy coating, deposited at 2.0 A dm −2 exhibited a lesser corrosion rate (14.71 × 10 −2 mm y −1 ) than those at higher current densities. The lowest corrosion rate was attributed to its least crystallite size (10.4 nm), evidenced by an X-Ray Diffraction (XRD) study. The corrosion performance of Ni–Fe alloy coatings was discussed in the light of their surface morphology and composition, evidenced by SEM and Energy-Dispersive X-ray spectroscopy (EDS) analysis, respectively. On a développé de manière galvanostatique des revêtements en alliage Ni–Fe en utilisant un nouveau bain à faible concentration. On a optimisé la composition et les paramètres de fonctionnement du bain en profitant de la méthode conventionnelle de la cellule de Hull. On a développé des revêtements en alliage Ni–Fe à différentes densités de courant (2.0 à 5.0 A dm −2 ), en maintenant le pH = 2.5. On a évalué dans une solution de NaCl à 3.5% le comportement à la corrosion des revêtements de l'alliage électrodéposés, en utilisant les méthodes de spectroscopie d'impédance électrochimique (EIS) et de polarisation potentiodynamique. Il s'est avéré que le revêtement en alliage Ni–Fe déposé à 2.0 A dm −2 présentait le taux de corrosion le plus faible (14.71 × 10 −2 mm an −1 ), comparé à ceux présentant des densités de courant plus élevées. Le taux de corrosion le plus faible était attribué à la plus petite taille de cristallite (10.4 nm), mise en évidence par une étude de diffraction des rayons X (DRX). On a discuté de la performance à la corrosion des revêtements en alliage Ni–Fe à la lumière de leur morphologie et de leur composition de surface, mises en évidence respectivement par analyse de microscopie électronique à balayage (MEB) et de spectroscopie de rayons X à dispersion d'énergie (EDS).

Electrolytic production and characterization of nickel–rhenium alloy coatings

Electroless plating of rhenium-based alloys with nickel, cobalt and iron

Ni-Cr Powders Modified with Rhenium as a Novel Coating Material-Physical Properties, Microstructure, and Behavior in Plasma Plume

Electroplating and Physicochemical Properties of Zinc–Nickel Alloy Coatings from Ammonium Oxalate Electrolytes

Electrochemical Behaviour of Nickel(II)-Rhenium(VII) And Electrodeposition Of Nickel-Rhenium Alloy From Choline Chloride - Urea Deep Eutectic Solvent

PECULIARITIES OF ELECTRODEPOSITION OF COBALT—WOLFRAM—RENIUM ALLOY

Morphologies and textures of rhenium coatings electrodeposited in chloride molten salts

Improvement of corrosion resistance of Ni-based alloy by adding 5 wt.% Rhenium

Production of High-Purity Anhydrous Nickel(II) Perrhenate for Tungsten-Based Sintered Heavy Alloys

Microstructure of Rhenium Doped Ni-Cr Deposits Produced by Laser Cladding

How to create a Ni-free corrosion protecting deposit on basis of ZnFe-X

Influence of rhenium on hot corrosion resistance of CoNiCrAlY coating alloys

Surface morphology, microstructure and emissivity of rhenium electrodeposited from molten salts

Electroplating and characterization of Zn–Ni, Zn–Co and Zn–Ni–Co alloys

Electrochemical Synthesis and Characterization of Ni–P Alloy Coatings from Eutectic–Based Ionic Liquid

Evaluation of corrosion resistance of electrodeposited nanocrystalline Ni–Fe alloy coatings

Electrochemical development and characterisation of nanostructured Ni–Fe alloy coatings for corrosion protection

Electrodeposition of Ni–Co alloys from a deep eutectic solvent

Microstructure Characteristics, Tribology and Nano-Hardness of Plasma Sprayed NiCrRe Coating

Preparation and Enhanced Isothermal Oxidation Resistance of a Low Diffusivity NiRePtAl Single-Phase Coating

The Performance of Zn-Ni Alloy Coating Electrodeposited from Stabilized Bath