Abstract:Due to the high integration on vertical stacked layers, power/ground network design becomes one of the critical challenges in 3D IC design. With the leakage-thermal dependency, the increasing on-chip temperature in 3D designs has serious impact on IR drop due to the increased wire resistance and increased leakage current. Power/ground (P/G) TSVs can help to relieve the IR drop violation by vertically connecting the on-chip P/G networks on different layers. However, most previous work only fulfills a margin of the full potential of PG TSVs planning since the P/G grids are restricted in a uniform topology. Besides, the overlook of resistance variation and leakage current will make the results less accurate. In this paper, we present an efficient thermal-aware P/G TSVs planning algorithm based on a sensitivity model with temperature-dependent leakage current considered. The proposed method can overcome the limitation of uniform P/G grid topology and make full use of P/G TSVs planning for the optimization of P/G network by allowing short wires to connect the P/G TSVs to P/G grids in non-uniform topology. Moreover, with resistance variation and increased leakage current caused by high temperature in 3D ICs, more accurate result can be obtained. Both the theoretical analysis and experimental results show the efficiency of our approach. Results show that neglecting thermal impacts on power delivery can underestimate IR drop by about 11%. To relieve the severe IR drop violation, 51.8% more P/G TSVs are needed than the cases without thermal impacts considered. Results also show that our P/G TSV planning based on the sensitivity model can reduce max IR drop by 42.3% and reduce the number of violated nodes by 82.4%.

IR-Drop in On-Chip Power Distribution Networks of ICs With Nonuniform Power Consumption

Design and Validate the Chip's Power-Network in DSM

Supply Noise and Impedance of On-Chip Power Distribution Networks in ICs With Nonuniform Power Consumption and Interblock Decoupling Capacitors

Silicon-Validated Power Delivery Modeling and Analysis on a 32-Nm DDR I/O Interface.

A Multicore Chip Load Model for PDN Analysis Considering Voltage–Current-Timing Interdependency and Operation Mode Transitions

Fast voltage drop modeling of power grid with application to silicon interposer analysis

Modeling and Characterization of On‐Chip Interconnects

Systematic Analysis for Static and Dynamic Drops in Power Supply Grids of 3-D Integrated Circuits

A New Method for Power-Aware Signal Integrity Analysis with Spice Model of Power Distribution Network

A Silicon-Validated Methodology for Power Delivery Modeling and Simulation

The maximum voltage drop in an on-chip power distribution network: analysis of square, triangular and hexagonal power pad arrangements

Effective Resistance Approach for DC Analysis of Power Grid on Through-Silicon Interposer (TSI)

Floorplanning with IR-drop Consideration

High-Frequency Electrothermal Characterization of TSV-Based Power Delivery Network

Power Integrity Analysis of TSV Based 3-D Integrated Circuits

Efficient And Accurate Modeling Of Power Supply Noise On Distributed On-Chip Power Networks

Model for estimating power dissipation along the interconnect length in single on-chip topology

Efficient Power Grid Integrity Analysis Using On-the-fly Error Check and Reduction

Plane-Pair PEEC Modeling for Package Power Layer Nets with Inductance Extraction

Electromagnetic Coupling Between Power Distribution Network and On-chip Inductors in Package

Thermal-aware Power Network Design for IR Drop Reduction in 3D ICs.