Abstract:Combustion system development in power generation is discussed ranging from the pre-environmental era in which the objectives were complete combustion with a minimum of excess air and the capability of scale up to increased boiler unit performances, through the environmental era (1970–), in which reduction of combustion generated pollution was gaining increasing importance, to the present and near future in which a combination of clean combustion and high thermodynamic efficiency is considered to be necessary to satisfy demands for CO2 emissions mitigation.From the 1970s on, attention has increasingly turned towards emission control technologies for the reduction of oxides of nitrogen and sulfur, the so-called acid rain precursors. By a better understanding of the NOx formation and destruction mechanisms in flames, it has become possible to reduce significantly their emissions via combustion process modifications, e.g. by maintaining sequentially fuel-rich and fuel-lean combustion zones in a burner flame or in the combustion chamber, or by injecting a hydrocarbon rich fuel into the NOx bearing combustion products of a primary fuel such as coal.Sulfur capture in the combustion process proved to be more difficult because calcium sulfate, the reaction product of SO2 and additive lime, is unstable at the high temperature of pulverized coal combustion. It is possible to retain sulfur by the application of fluidized combustion in which coal burns at much reduced combustion temperatures. Fluidized bed combustion is, however, primarily intended for the utilization of low grade, low volatile coals in smaller capacity units, which leaves the task of sulfur capture for the majority of coal fired boilers to flue gas desulfurization.During the last decade, several new factors emerged which influenced the development of combustion for power generation. CO2 emission control is gaining increasing acceptance as a result of the international greenhouse gas debate. This is adding the task of raising the thermodynamic efficiency of the power generating cycle to the existing demands for reduced pollutant emission. Reassessments of the long-term availability of natural gas, and the development of low NOx and highly efficient gas turbine–steam combined cycles made this mode of power generation greatly attractive also for base load operation.However, the real prize and challenge of power generation R&D remains to be the development of highly efficient and clean coal-fired systems. The most promising of these include pulverized coal combustion in a supercritical steam boiler, pressurized fluid bed combustion without or with topping combustion, air heater gas turbine-steam combined cycle, and integrated gasification combined cycle. In the longer term, catalytic combustion in gas turbines and coal gasification-fuel cell systems hold out promise for even lower emissions and higher thermodynamic cycle efficiency. The present state of these advanced power-generating cycles together with their potential for application in the near future is discussed, and the key role of combustion science and technology as a guide in their continuing development highlighted.

Assessment of Fluidized Bed Oil Gasification for Power Generation

Examination of Industrial Demonstration Unit of Coal Gasification for Pulverized Coal with Ash Agglomeration Technique

A Summary on Acceptance of a Model for Commercialization of Circulated Fluid Bed Gasification of Pulverized Caol

Feasibility Study for Blended Gas Fuel Combustion in Boilers of Thermal Power Plant

Co-gasification of Acid Hydrolysis Residues and Sewage Sludge in a Downdraft Fixed Gasifier with CaO As an In-Bed Additive

Development of Coal Partial Gasification and Combustion System

Sulfur Removal at High Temperature During Coal Combustion in Furnaces: A Review

Proposal and investigation of a high-efficiency coal-fired power generation system enabled by chemical recuperative supercritical water coal gasification

Current advances and future prospects of in-situ desulfurization processes in oxy-fuel combustion reactors

A Study of High Temperature Desulfurization and Regeneration Using Iron-Calcium Oxides in a Fixed-Bed Reactor

Technical and Economic Assessments of a novel biomass-to-synthetic natural gas (SNG) process integrating O2-enriched air gasification

The Return of Coal-Fired Combined Heat and Power Plants: Feasibility and Environmental Assessment in the Case of Conversion to Another Fuel or Modernizing an Exhaust System

A Dry Process for Simultaneous Removal of SO2 and NO from Flue Gas of Power Plants by Using a Gas-Solid-Solid Fluidized Bed

An Air-Fuel Ratio Parametric Assessment on Efficiency and Cost of a Power Plant Steam Boiler

Appraisal of SOx Emission from Flue Gas in Thermal Power Station and Dry Sorbent Injection (DSI) Method to Reduce SOx

An Experimental And Response-Surface-Based Optimization Approach Towards Production Of Producer Gas In A Circulating Fluidized Bed Gasifier Using Blends Of Renewable Fibre-Based Biomass Mixtures

Numerical study on sulfur-bearing natural gas oxy-fuel combustion power plant

Research progress of hot gas filtration, desulphurization and HCl removal in coal-derived fuel gas: A review

High-Temperature Sulfur Removal Under Fluidized-Bed Combustion Conditions - A Chemical Interpretation

Combustion technology developments in power generation in response to environmental challenges

Experiments of Sulfur Removal in 1MW Poly-Generation System with Partial Gasification and Combustion Combined