Abstract:The search continues for alternative nontoxic n-type electron transport layers in optoelectronic thin-film devices. Indium oxysulfide, In 2 (O,S) 3 , represents one promising material for this application, especially when paired with chalcogenide absorber layers. The ternary nature of the composition allows for electrical conductivity and optical bandgap tuning by tailoring the sulfur to oxygen ratio in the oxysulfide alloy. However, thin films of In 2 (O,S) 3 are typically deposited only by chemical bath deposition or plasma-enhanced atomic layer deposition. We report deposition of thin films of In 2 (O,S) 3 in a custom-built thermal reactor using only water vapor and hydrogen sulfide as the coreactants. This advance is enabled by the use of a recently reported, highly reactive indium formamidinate precursor. As shown by x-ray photoelectron spectroscopy, the composition can be tuned from pure In 2 O 3 to pure In 2 S 3 by varying the ratio of cycles employing water or hydrogen sulfide. The oxygen to the sulfur ratio in the film can be controlled by altering the dose sequence, although films typically contain more sulfur than would be expected naively from the percentage of hydrogen sulfide doses in the deposition recipe. Rutherford backscattering spectrometry confirms the composition is sulfur-rich relative to the dosing ratio. Structural characterization indicates films are relatively amorphous in nature. Electrically, these films offer reasonably constant electron mobility at different O:S ratios, with an electron concentration tunable over 4 orders of magnitude. These oxysulfide films possess a higher indirect bandgap than their oxygen-free indium sulfide counterparts, indicating higher transmittance to blue light. These indium oxysulfide films may be suitable candidates for electron transport layers in thin-film solar cells where their wider bandgap might result in higher optical transparency and thus short circuit current density, while the tunability of their conduction band offset with an absorber layer may result in higher open circuit voltage.

Transport properties of indium sulfide thin films deposited by chemical bath deposition

Fabrication and characterization of CuInS 2 films by chemical bath deposition in acid conditions

Optical and Structural Properties of Indium Sulfide Thin Film Produced by CBD Method

Preparation of Indium Hydroxy Sulfide In x ( OH ) y S z Thin Films by Chemical Bath Deposition

Effect of annealing on structural and optical properties of indium sulfide thin layers produced by chemical bath deposition method

Surface Pattern and Optical Properties of In-doped ZnO Thin Films by Hydrothermal Method

Optical and structural properties of indium doped bismuth selenide thin films

Simple thermal vapor deposition process for and characterization of n-type indium oxysulfide thin films

Surface characterization of Cu-doped indium sulfide thin films

Effect of Heat Treatment on the Property of Cuins2 Thin Film Prepared by Chemical Bath Deposition

Research on CuInS2 Thin Films Prepared by One-step Electrodeposition

EFFECT OF INDIUM DOPING ON STRUCTURAL, OPTICAL AND ELECTRICAL PROPERTIES OF CADMIUM SULFIDE THIN FILMS

Controlled Deposition of Silver Indium Sulfide Ternary Semiconductor Thin Films by Chemical Bath Deposition

Thorough investigation of the optical, electrical and thermal properties of Cu3Se2 thin film deposited by chemical bath deposition

Effect of different dopants on the structural and physical properties of In2S3 thin films: a review

Electrodeposition of indium antimonide (InSb) from dimethyl sulfoxide-based electrolytes

EFFECT OF ANNEALING ON THE CuInS2 THIN FILMS PREPARED BY CHEMICAL BATH DEPOSITION

Preparation and Properties of CuInS2 Thin Film Deposited by Single-Source Thermal Evaporation

Preparation of InSe Thin Films by Thermal Evaporation Method and Their Characterization: Structural, Optical, and Thermoelectrical Properties

PHOTOTHERMAL DEFLECTION ANALYSIS OF [math]-In2S3 THIN FILMS: THE EFFECT OF S/In MOLAR RATIOS

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition