Porous Carbon Fiber Flow Fields for Heavy-Duty Polymer Electrolyte Fuel Cell (PEFC) Applications
Preetam Sharma,Jon Owejan,Douglas Aaron,Matthew M Mench
DOI: https://doi.org/10.1149/ma2023-01382255mtgabs
2023-09-20
ECS Meeting Abstracts
Abstract:The US Department of Energy (DOE) interim (2030) targets for polymer electrolyte fuel cells (PEFCs) in heavy duty vehicle applications accentuate reduced system cost (US 3.5/kW net ), which is 17% higher than current DOE target [1]. Thus, low-cost substrate alternatives are required to reduce the cost and facilitate commercialization in heavy-duty applications. One such alternative is a novel PEFC architecture [5] utilizing a laminated structure consisting of flat thin metal foils that separate flow fields with channels formed into the porous gas diffusion layer (GDL). This architecture enables the use of much thinner metal plates compared to stamped ones, reducing the overall system mass and cost. The current study explores the performance of a wide aspect ratio (200 mm x 30 mm) PEFC test fixture with porous carbon fiber flow field compared to conventional solid flow field over a wide range of operating conditions. The wide aspect ratio and channel/rib dimensions for both the porous and the conventional solid flow field are chosen to provide a reasonable pressure loss relevant to heavy-duty PEFC stack application. This new architecture is expected to enable comparable system performance while reducing plate weight and cost. References: [1] D. A. Cullen et al., "New roads and challenges for fuel cells in heavy-duty transportation," Nat Energy, vol. 6, pp. 462–474, 2021, doi: 10.1038/s41560-021-00775-z. [2] W. Yuan, Y. Tang, X. Yang, and Z. Wan, "Porous metal materials for polymer electrolyte membrane fuel cells - A review," Applied Energy, vol. 94. Elsevier Ltd, pp. 309–329, 2012. doi: 10.1016/j.apenergy.2012.01.073. [3] R. Taherian, "A review of composite and metallic bipolar plates in proton exchange membrane fuel cell: Materials, fabrication, and material selection," Journal of Power Sources, vol. 265. Elsevier B.V., pp. 370–390, Nov. 01, 2014. doi: 10.1016/j.jpowsour.2014.04.081. [4] A. K. Srouji, L. J. Zheng, R. Dross, A. Turhan, and M. M. Mench, "Performance and mass transport in open metallic element architecture fuel cells at ultra-high current density," J Power Sources, vol. 218, no. 2012, pp. 341–347, 2012, doi: 10.1016/j.jpowsour.2012.06.075. [5] J. P. Owejan and S. G. Goebel, "Performance evaluation of porous gas channel ribs in a polymer electrolyte fuel cell," J Power Sources, vol. 494, no. December 2020, 2021, doi: 10.1016/j.jpowsour.2021.229740.