Corrosion resistant and conductive TiN/TiAlN multilayer coating on 316L SS: a promising metallic bipolar plate for proton exchange membrane fuel cell

S. Pugal Mani,M. Kalaiarasan,K. Ravichandran,N. Rajendran,Y. Meng
DOI: https://doi.org/10.1007/s10853-020-05682-4
IF: 4.5
2021-03-04
Journal of Materials Science
Abstract:The single layers of TiN, TiAlN and TiN/TiAlN multilayer coatings were deposited on 316L SS bipolar plate by physical vapor deposition technique. The X-ray diffraction studies revealed that the formed coatings exhibited single-phase cubic structure. The low surface roughness and high contact angles of the TiAlN and TiN/TiAlN coatings governed the better water management in the fuel cell. Nyquist and Bode-impedance studies of TiN/TiAlN coating ensured higher electrochemical impedance behavior. The polarization results revealed that the current densities (icorr) of TiN/TiAlN coating were below 1 µA/cm2 in the PEMFC environments, which satisfied the U.S. Department of Energy’s 2020 target. The contact resistance of the TiN/TiAlN-coated 316L SS was the lowest and fulfilled the requirements of bipolar plate (≤ 10 mΩ cm2) in PEMFC environment. Surface morphology results revealed that the surface of 316L SS is well protected by multilayer TiN/TiAlN coating. Inductive coupled plasma-optical emission spectroscopy results are in good agreement with electrochemical studies revealing the TiN/TiAlN coating significantly reduced the metal ions dissolution.
materials science, multidisciplinary
What problem does this paper attempt to address?