Abstract:Abstract When the fine-blanking process is used, secondary grinding or processing can be omitted because the shear surface of fine-blanking parts can achieve almost zero fracture zone requirements. The primary objective of the fine-blanking process is to reduce the fracture zone depth and die roll zone width. This study used a 2.5-mm-thick central processing unit (CPU) thermal heat spreader as an example. Finite element analysis software was employed to simulate and optimize the main eight process parameters that affect the fracture zone depth and die roll zone width after fine-blanking: the V-ring shape angle, V-ring height of the blank holder, V-ring height of the cavity, V-ring position, blank holder force, counter punch force, die clearance, and blanking velocity. Simulation analysis was conducted using the L 18 (2 1 × 3 7 ) Taguchi orthogonal array experimental combination. The simulation results of the fracture zone depth and die roll zone width were optimized and analyzed as quality objectives using Taguchi’s smaller-the-better design. The analysis results revealed that with fracture zone depth as the quality objective, 0.164 mm was the optimal value, and counter punch force made the largest contribution of 25.89%. In addition, with die roll zone width as the quality objective, the optimal value was 1.274 mm, and V-ring height of the cavity made the largest contribution of 29.45%. Subsequently, this study selected fracture zone depth and die roll zone width as multicriteria quality objectives and used the robust multicriteria optimal approach and Pareto-optimal solutions to perform multicriteria optimization analysis. The results met the industry’s fraction zone depth standard (below 12% of blank thickness) and achieved a smaller die roll zone width.

A Novel Force Variation Fine Blanking Process for the High-strength and Low-plasticity Material

Parameters Optimization of Tailor Welded Blank Forming Process

Numerical simulation and optimization of process parameters in fineblanking process

OPTIMIZATION DESIGN VARIABLE BLANKHOLDER FORCE IN SHEET METAL FORMING

Numerical simulation of fine-blanking process using a mixed finite element method

Advances in Forming Simulation for Fine-Blanking Process

Finite element optimization of veering factor in fine-blanking process

An Investigation of Step-Shaped-punch Fine-Blanking Process Using Finite Element Method

Fine-blanking Process Simulation by Rigid Viscous-Plastic FEM Coupled with Void Damage

Numerical Optimization of Variable Blank Holder Force Trajectories in Stamping Process for Multi-Defect Reduction

State-of-the-art and Future Challenge in Fine-Blanking Technology

Ductile Damage and Simulation of Fine-Blanking Process by FEM

Numerical simulation and optimization of fine-blanking process for copper alloy sheet

A New Strategy to Optimize Variable Blank Holder Force Towards Improving the Forming Limits of Aluminum Sheet Metal Forming

A New Strategy for the Optimization of Variable Blank Holder Force in Sheet Metal Forming

Ductile Fracture in Fine-Blanking Process

Effect of grain size on fine micro-blanking for Inconel 718 foil

FEM model optimization study of mechanical properties and material selection in stamping process

A Study of Fine Blanking Process by Fem Simulation

The Optimization Study of Variable Blank Holder Force in the Process of Deep Drawing Cylinder Parts

Numerical Simulation on Reciprocated Fine Blanking Process