Abstract:The transient process of a centrifugal pump existed in a variety of occasions. There were a lot of researches in the external characteristic in startup process and stopping process, but internal characteristics were less observed and studied. Study of the internal flow field had significant meanings. The performance of a pump could be evaluated and improved by revealing the flow field. In the other hand, the prediction of external characteristic was based on the correct analysis of the internal flow. In this paper, theoretical method and numerical simulation were used to study the internal characteristic of a centrifugal pump. The theoretical study showed that the relative flow in an impeller was composed of homogeneous flow and axial vortex flow. The vortex intensity was mainly determined by angular velocity of impeller, flow channel width and blade curvature. In order to get the internal flow field and observe the evolution of transient internal flow in the impeller, Computational Fluid Dynamics(CFD) were used to study the three-dimensional unsteady incompressible viscous flows in a centrifugal pump during starting period. The Dynamic Mesh (DM) method with non-conformal grid boundaries was applied to get the external characteristic and internal flow field. The simulate model included three pumps with different blade numbers and the same blade curvature. The relative velocity vector showed that there was a big axial vortex in impeller channel. At the beginning, the vortex was raised in the pressure side of the impeller outlet and with time went on, it shifted to the middle flow channel of the impeller and the vortex intensity increased. When the speed and flow rate reached a definite value, the influence of the axial vortex began to get smaller. The vortex developed faster when the flow channel got narrower. Due to the evolution of axial vortex, the slip factor during starting period was smaller than that in quasi-steady condition. As a result, transient head was lower than quasi-steady head in startup process.

Analysis of Internal Flow Characteristics of a Startup Pump Turbine at the Lowest Head under No-Load Conditions

Analysis of Inter-blade Vortex and Runner Blades Force of Pump Turbine during Load Rejection Period

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Distribution Features of Flow Patterns and Pressure Pulsations of Pump-Turbine in Five Operating Modes on the Four-Quadrant Plane

Pressure pulsation in small opening operating mode of pump turbine’s turbine mode

Study on Internal Flow Characteristics and Pressure Pulsation Features of Pump-Turbine under the No-Load Startup Condition with Different Heads

Analysis of the Flow Behavior and Pressure Fluctuation of a Pump Turbine with Splitter Blades in Part-Load Pump Mode

Numerical simulation of the unstable flow phenomenon in a pump turbine at the load rejection conditions in turbine mode

Study on the flow characteristic of pump turbine at partial load

Study on Transient Flow Characteristics of Pump Turbines During No-Load Condition in Turbine Mode Startup

The Influence of Hydraulic Characteristics on Structural Performance in a Pump-Turbine under No-Load Conditions

Analysis of Flow and Runner Dynamic Response Characteristics under Pump Conditions of Variable-Speed Pump Turbine

Prediction on the axial water thrust characteristics of pump turbine runner under partial load

Transient Internal Characteristic Study of a Centrifugal Pump During Startup Process

Unsteady Flow Analysis of Pump Mode Small Discharge Condition for a Francis Pump-turbine

Three-dimensional simulation of unsteady flows in a pump-turbine during start-up transient up to speed no-load condition in generating mode

Flow-induced Vibration Analysis of a Prototype Pump-Turbine Runner During Turbine Start-Stop Transient Process

Analysis of Flow Characteristics in Pumped Storage Unit During Start-Up in Turbine Mode

Investigations into Hydraulic Instability during the Start-Up Process of a Pump-Turbine under Low-Head Conditions

Pulsation Stability Analysis of a Prototype Pump-Turbine during Pump Mode Startup: Field Test Observations and Insights

Flow-Induced Vibration of Non-Rotating Structures of a High-Head Pump-Turbine during Start-Up in Turbine Mode