Structural and compositional analysis of nickel phases at anode/ electrolyte interface using propane/air-oriented syngas
Yue Ma,Huazheng Yang,Chenpeng Wang,Jiawei Liu,Yinglong Liu,Hao Ye,Zhicong Chen,Yingli Liu,Xiaoru Xu,Yingbang Yao,Tao Tao,XiaoBo Zhao,Libin Lei,Chao Wang,Shengguo Lu,Gang Wu,Bo Liang
DOI: https://doi.org/10.1016/j.ijhydene.2023.04.287
IF: 7.2
2023-05-11
International Journal of Hydrogen Energy
Abstract:Syngas produced by catalytic partial oxidation (CPOX) of propane contains hydrogen (21.68%) and carbon monoxide (18.27%). Microtubular solid fuel cells (μT-SOFCs) were fabricated and tested with syngas and pure hydrogen respectively. The open-circuit voltage (OCV) is 1.02 V, and the maximum power (MP) of microtubular solid fuel cell is 7.07 W at 700 °C with syngas/air. After operating in syngas/air for 100 h, the voltage declined 4.5%. A few sites of anode separate from electrolyte, particularly, some few nanometers nickel (Ni) particles have precipitated at the interface of electrolyte/anode. Comparing to Ni grain with 200 nm-1 μm diameter in rest sites of anode, it is easy to explain the loss of Ni and the separation of anode with electrolyte. Meantime obvious carbon deposition is found at the pores after 100 h working in syngas/air. There are other impurity phases discovered by high resolution transmission electron microscopy (HRTEM) at a triple phase boundary (TPB) of electrolyte and anode.
energy & fuels,electrochemistry,chemistry, physical