Abstract:With the rapid development of high-speed railway (HSR) in China, the problem of environmental vibration induced by HSR train has attracted critical concern. In this paper, a combination vibration reduction (CVR) strategy of hollow-closed-wall in-filled trench (HIT) and elastic bearing (EB) is proposed to decrease environmental vibration induced by HSR train, in which the depth of HIT could be well controlled to benefit the practical construction and economic cost. Based on the multi-body dynamics and finite element theory, HSR environmental vibration system is established and then divided into two sub-models including the 'train-track-bridge' vibration source sub-model and the 'pile-soil' vibration propagation sub-model. The two sub-models are connected via the force balance condition of the pier bottom. The verification of numerical models is conducted by comparing with the empirical formula and the ground data in the references. Then the attenuation law of environmental vibration is analyzed, and the vertical component is shown to be dominant in the HSR environmental vibration. On this basis, numerical simulations are performed to analyze the environmental vibration reduction under three strategies, namely the HIT, EB, and CVR. The results show that the HIT presents a distinct vibration reduction effect in the frequency range above 4 Hz and the vibration reduction becomes more obvious as the HIT's depth increases. However, the depth should be larger than 8 m to satisfy the code requirement; the EB presents an obvious reduction in the frequency range above 8 Hz; the CVR strategy not only further decrease the environmental vibration, but also effectively reduce the HIT's depth. By numerical analysis, the combination strategy of 6 m deep HIT and 2200 kN/mm vertical stiffness EB is recommended in the HSR environmental vibration reduction, which could also satisfy the limit of Chinese railway code.

Effect Analysis on Vibration Isolation by Nonstandard Continuous Barriers

Investigation of Environmental Vibration Control for High Speed and Heavy Haul Railway

3D Numerical Analysis for Traffic Reduction Induced Ground Vibration

A Combination Strategy of Hollow-Closed-wall In-Filled Trench and Elastic Bearing for Reducing Environmental Vibration Induced by High-Speed Train

Numerical analysis of engineered metabarrier effect on ground vibration induced by underground high-speed train

Analysis of the Vibration Isolation Effect of the Railway Rigid Sandwich Wall

A Parametric Study of Wave Barriers for Reduction of Train-Induced Vibrations

Wave Barriers For Reduction Of Train-Induced Vibrations

A Theoretical Investigation on Characteristic Frequencies of Ground Vibrations Induced by Elevated High Speed Train

Effects of Steel Spring Floating Slab on Vibration and Noise of a Rail Transit Box-Girder

Vibration control mechanism of the metabarrier under train load via numerical simulation

Predict the Influence of Environmental Vibration from High-Speed Railway on Over-Track Buildings

Mitigation of Railway-Induced Vibrations by Using Periodic Wave Impeding Barriers

Dynamic Response Analysis of Sound Barrier Structures under High Speed Train Traveling Condition

Vibration isolation of over-track buildings in a metro depot by using trackside wave barriers

Investigation of the vibration isolation effect of composite vibration isolation walls on ground surface vibrations in deep tunnels of suburban railways

Study on Isolation Efficiency of Floating Slab Track Using a Numerical Prediction Model of Metro Traffic Induced Vibrations

Wave Barriers For Reduction Of Train-Induced Vibrations In Soils

Acoustic–vibration characteristics and low–structural–noise optimization design of upright sound barrier for rail transit

On Effectiveness of Vibration Isolation Using Super-Elastic Rail Support Combined with Booted Sleeper or Floating Slab

Study of effect on sensitive equipment due to vibrations induced by metro traffic