Abstract:The development of a realistic numerical model that predicts the impact behavior of adhesively bonded composite joints is important for many industrial sectors such as automotive, aerospace, and marine. In this study, it was aimed to develop a numerical model that can predict the low-velocity oblique impact behavior of composite single-lap joints close to the experimental results. The validation of the proposed numerical model was carried out with the results of the previously experimentally tested joints. In explicit finite element analysis, the orthotropic material model and Hashin's damage criterion were used in the numerical model of composite adherends. The adhesive region was divided into three different regions. The cohesive zone model (CZM) was used to determine the damage initiation and propagation in the upper and lower interface regions of adhesive. The middle region of the adhesive between the two cohesive interfaces was modeled with an elastic–plastic material model to reflect the plastic material behavior of the adhesive in the analysis. The effects of impact angle, fiber orientation, and overlap length on adhesive damage initiation and propagation were investigated in detail. There is a good agreement between the numerical and experimental results, considering the contact force-time variations and composite and adhesive damage. The impact angle and fiber angle had a significant effect on the impact behavior of the composite joints and the adhesive damage initiation and propagation. The increase in impact angle and fiber angle caused a decrease in the maximum contact force value. Adhesive damage propagation patterns varied according to the composite fiber orientation. In addition, since the shear toughness of the adhesive is higher than its tensile toughness, the amount of adhesive damage and damage propagation rate decreased as the impact angle increased.

Influence of π overlaminates on the mechanical behavior of all-composite adhesively bonded π joints

Strength prediction of composite π joint under bending load and study of geometric and material variations effects

Strengthening of Composite T-joints Using Ø 0.11 Mm Z-pins Via an Ultrasound-Guided Insertion Process

Effect of Ø 0.11 Mm Z-pinning on the Properties of Composite Laminates Via an Ultrasound Guided Insertion Process

Influence of Fiber Cutting at the Composite Grid Intersection on the Compressive Performance of Laminate

Three-dimensional progressive damage models for cohesively bonded composite π joint

Experimental investigations of bolted, adhesively bonded and hybrid bolted/bonded single-lap joints in composite laminates

Experimental Investigation of Z-pin Insertion Angles on the Mechanical Behavior and Failure Mechanism of Compression after Impact for CFRP Laminates

Material and adhesive effect in adhesively-bonded composite stepped-lap joints

Failure prediction of marine non-planar composite π joints based on combined 2D material model and progressive damage method

An average failure index method for the tensile strength prediction of composite adhesive-bonded π joints

Influence of Failure-Load Prediction in Composite Single-Lap Joints with Brittle and Ductile Adhesives Using Different Progressive-Damage Techniques

A detailed experimental parametric analysis of bolted and hybrid bolted/bonded composite joints

Mechanical properties of all-C/C composite hybrid bonded/bolted joints

Mechanistic Study of Failure in CFRP Hybrid Bonded–Bolted Interference Connection Structures under Tensile Loading

Investigation on the Progressive Damage and Bearing Failure Behavior of Composite Laminated Bolted Joints under Tension

Study on mechanical behavior of adhesively bonded laminated envelope composite joints

Finite Element Analysis of Low-Speed Oblique Impact Behavior of Adhesively Bonded Composite Single-Lap Joints

Experimental and Numerical Study of Low-Velocity Impact and Tensile after Impact for CFRP Laminates Single-Lap Joints Adhesively Bonded Structure

Numerical and experimental investigation on the load‐bearing performance of plain‐woven composites hybrid bonded‐bolted joints

The structural response of the thermoplastic composite joint subjected to out-of-plane loading