Abstract:In this paper, an in situ piezoelectric-fiber hybrid sensor network was developed to monitor the life-cycle of carbon fiber-reinforced plastics (CFRPs), from the manufacturing phase to the life in service. The piezoelectric lead-zirconate titanate (PZT) sensors were inserted inside the composite structures during the manufacturing process to monitor important curing parameters, including the storage modulus of resin and the progress of the reaction (POR). The strain that is related to the storage modulus and the state of resin was measured by embedded fiber Bragg grating (FBG) sensors, and the gelation moment identified by the FBG sensors was very close to those determined by dynamic mechanical analysis (DMA) and POR. After curing, experiments were conducted on the fabricated CFRP specimen to investigate the damage identification capability of the embedded piezoelectric sensor network. Furthermore, a modified probability diagnostic imaging (PDI) algorithm with a dynamically adaptive shape factor and fusion frequency was proposed to indicate the damage location in the tested sample and to greatly improve the position precision. The experimental results demonstrated that the average relative distance error (RDE) of the modified PDI method was 68.48% and 46.97% lower than those of the conventional PDI method and the PDI method, respectively, with an averaged shape factor and fusion frequency, indicating the effectiveness and applicability of the proposed damage imaging method. It is obvious that the whole life-cycle of CFRPs can be effectively monitored by the piezoelectric-fiber hybrid sensor network.

Real-Time Life-Cycle Monitoring of Composite Structures Using Piezoelectric-Fiber Hybrid Sensor Network

In-situ Cure Monitoring of Thick CFRP Using Multifunctional Piezoelectric-Fiber Hybrid Sensor Network

Life-cycle health monitoring of composite structures using piezoelectric sensor network

Cure monitoring and damage identification of CFRP using embedded piezoelectric sensors network

Life-Cycle Monitoring of CFRP using Piezoelectric Sensors Network

Embedded Piezoresistive Sensor Network for Multi-Failure Mode Monitoring in CFRP Bolted Joints

An implantable, compatible and networkable nanocomposite piezoresistive sensor for in situ acquisition of dynamic responses of CFRPs

Real-time self-monitoring and smart bend recognizing of fiber-reinforced polymer composites enabled by embedded magnetic fibers

Embedded Pt-PVDF sensor without compromising mechanical properties of GFRP for on-line sensing

Structural Health Monitoring of Smart Composite Materials by Using EFPI and FBG Sensors

In-situ Monitoring of Failure Modes in Composite Bolted Joint Structures Using CB/CNT Piezoresistive Sensor

An Embedded Non-Intrusive Graphene/epoxy Broadband Nanocomposite Sensor Co-Cured with GFRP for in Situ Structural Health Monitoring

Monitoring of Three-Dimensional Resin Flow Front Using Hybrid Piezoelectric-Fiber Sensor Network in a Liquid Composite Molding Process

Damage Detection for Composite Laminate Plates with A Distributed Hybrid PZT/FBG Sensor Network

Low-cost sensor-based damage localization for large-area monitoring of FRP composites

Ultrasound tomography for health monitoring of carbon fibre–reinforced polymers using implanted nanocomposite sensor networks and enhanced reconstruction algorithm for the probabilistic inspection of damage imaging

Application of piezoelectric MFC sensors and fiber Bragg grating sensors in structural health monitoring of composite materials

Built-in Sensor Network for Structural Health Monitoring of Composite Structure

Debonding Detection and Monitoring for CFRP Reinforced Concrete Beams Using Pizeoceramic Sensors.

Structural Health Monitoring of Repairs in Carbon-Fiber-Reinforced Polymer Composites by MWCNT-Based Multiscale Sensors

In-situ monitoring of liquid composite molding process using piezoelectric sensor network