Life-Cycle Monitoring of CFRP using Piezoelectric Sensors Network

DOI: https://doi.org/10.21741/9781644901311-15

2021-02-20

Abstract:Abstract. Vacuum Assisted Resin Infusion (VARI) process is suitable for manufacturing complex large-scale composite structures and has the potential for low cost and mass production. However, the inappropriate process parameters such as incomplete resin flow and the uneven cure occurred will lead to some defects such as dry spots and delamination. In the present work, the concept of Networked Elements for Resin Visualization and Evaluation (NERVE) with the piezoelectric lead-zirconate-titanate (PZT) sensors as the base unit was used to monitor the internal state of composite struture during its life-time. The capability of PZT sensors in the NERVE to monitor two important parameters during the manufacturing process including the flow front of resin and progress of reaction (POR), was investigated. The Lamb waves generated by PZT, propagating in the mold/composite, was used to measure the parameters. The resin flow front was analyzed using optical detection at the same time. The flow front position over time and the influence of the length of sensing path covered by resin were delivered. The effects of different resin cure state on Lamb signal attenuation and energy leakage were also obtained. The change of amplitude was integrated to get the POR curves, so the resin cure state could be also monitored. After the composite was demoulded, the network was used contiously to identify the artifical damages with the fused probability-based diagnostic imaging (PDI). Experimental results indicate that the NERVE has the ability to realize the full life-cycle health monitoring of composite structures.