EXPERIMENTAL INVESTIGATION ON SURFACE INTEGRITY OF END MILLING NICKEL-BASED ALLOY— INCONEL 718

Xiaojiang Cai,Sheng Qin,Junli Li,Qinglong An,Ming Chen

DOI: https://doi.org/10.1080/10910344.2014.863627

2014-01-02

Machining Science and Technology

Abstract:Inconel 718 is a typical difficult-to-machine material, and its high speed end milling process has wide applications in manufacturing parts from aerospace and power industry. Surface integrity of these parts greatly influences the final characteristics. This paper presents an experimental investigation to evaluate surface integrity behaviors in high speed end milling of Inconel 718 with finishing cutting parameters in terms of surface topography, surface roughness Ra, residual stresses, subsurface microstructure, and microhardness. The results show that abraded marks can be observed on the machined surfaces, and high cutting speed is advisable to get better surface topography and roughness quality. Due to high cutting temperature, residual stress is mainly high tensile stress. After increasing the cutting speed beyond 80m/min, the cutting forces hardly increased and the chips take away more cutting heat, which leads to that the residual stress barely increases. Microstructures in subsurface layers have only slight deformations after high speed milling, and there was also no obvious difference when the cutting speed increased beyond 80m/min against the microhardness in subsurface increases together with the cutting speed.

engineering, mechanical, manufacturing,materials science, multidisciplinary