Abstract:Wireless Power Transfer (WPT) brings convenience and safety in many applications and serves as a research hot spot in recently years. Magnetic resonant coupling is widely implemented in WPT applications such as mobile devices and electric vehicles where large distance, large power amount and high efficiency are the three key requirements in real application. However, there are always trade-offs between these requirements even in theory. Former literatures failed to illustrate the complete relationships between these requirements. Based on the phasor analysis, this paper illustrates the operating principle of the whole circuit, attains the equivalent circuit models of the system and derives the physical essence of frequency characteristics. Then Maximum Efficiency Conditions (MEC), which achieves the maximum efficiency without sacrificing the requirements for power transfer distance and power amount, is summarized. It should be noted that the highest efficiency is achieved at the natural frequency of the receiver, instead of any split frequencies of the coupled resonances. Following the MEC, a WPT prototype was designed, which was composed of a full bridge inverter, a LC resonant transmitter, a LC resonant receiver and a full bridge rectifier. The resonant frequency of the transmitter was designed to be slightly lower than the inverter operation frequency-446kHz to make an inductive load for the inverter so that all the MOSFETs operated in Zero-Voltage-Switching (ZVS) condition. For the experimental results, 300 W output power was obtained over a distance of 22cm with 84% overall efficiency.

Self-tuning Wireless Power Transmission Scheme Based on On-line Scattering Parameters Measurement and Two-side Power Matching

A study of the self-coupling magnetic resonance coupled wireless power transfer

Design and Optimization of a Modular Wireless Power System Based on Multiple Transmitters and Multiple Receivers Architecture

Optimal parameters design for series-series resonant converter for wireless power transfer

Self-adaptive Resonance Technology for Wireless Power Transfer Systems to Eliminate Impedance Mismatches

A Self-Tuning S/S Compensation WPT System Without Parameter Recognition

An Adaptive Impedance Matching System With Fast Optimization Control Algorithm for Wireless Power Transfer via Magnetic Coupling Resonance

Wireless Power Transfer Self‐adaptive to Incident Power Density

Receiver Resonant Frequency Adaptive Tracking in Wireless Power Transfer Systems Using Primary Variable Capacitor

The Efficiency Characteristics Analysis and Optimization of the Magnetic Resonance Wireless Power Transmission to Multiple Receivers

A Maximum Efficiency Point Tracking Control Scheme for Wireless Power Transfer Systems Using Magnetic Resonant Coupling

High Frequency Conducted EMI Modeling of a Series-Series Resonant WPT System

Research and Optimization of Transmission Characteristics of Magnetic Coupled Resonant Wireless Charging System

Research on Transfer Mechanism and Power Improvement Technology of the SCC-WPT System

A three-phase WPT system with self-regulation of phase sequence

Study on Efficiency Maximization Design Principles for Wireless Power Transfer System Using Magnetic Resonant Coupling

Precise Modeling and Design of Self-Resonant for High-Efficiency Mid-Range Wireless Power Transfer System

Study of a Magnetic Coupling Resonant Wireless Power Transfer System

Active Resonance Wireless Power Transfer System Using Phase Shift Control Strategy

Design and Efficiency Optimization of Asymmetric Magnetic Coupled Resonant Wireless Power Transfer System

A Study of Electromagnetic Emission from Two-Coil Wpt System Using Resonant Magnetic Field Coupling